General Description
The Realtek RTL8192SE is a highly integrated single-chip MIMO (Multiple In, Multiple Out) Wireless LAN (WLAN) solution for the wireless high throughput 802.11n draft specification. It combines a MAC, a 2T2R capable baseband, and RF in a single chip. The RTL8192SE provides a complete solution for a high throughput performance wireless client.
The RTL8192SE baseband implements Multiple Input, Multiple Output (MIMO) Orthogonal Frequency Division Multiplexing (OFDM) with 2 transmit and 2 receive paths (2T2R) and is compatible with the IEEE 802.11n Draft specification 2.0. Features include two spatial streams transmission, short guard interval (GI) of 400ns, spatial spreading, and transmission over 20MHz and 40MHz bandwidth. The RTL8192SE also supports explicit sounding packet feedback that helps senders with beamforming capability. With 2 independent RF blocks, the RTL8192SE can perform fast roaming without link interruption.
Features
General
■ 68-pin QFN
■ CMOS MAC, Baseband MIMO PHY, and
RF in a single chip for IEEE 802.11b/g/n
compatible WLAN
■ Complete 802.11n MIMO solution for
2.4GHz band
■ 2x2 MIMO technology for extended
reception robustness and exceptional
throughput
■ Maximum PHY data rate up to 144.4Mbps
using 20MHz bandwidth, 300Mbps using
40MHz bandwidth
■ Compatible with 802.11n draft 2.0
specification
■ Backward compatible with 802.11b/g
devices while operating at 802.11n data rates
Host Interface
■ Complies with PCI Express Base
Specification Revision 1.1
Standards Supported
■ IEEE 802.11e QoS Enhancement (WMM,
WMM-SA Client mode)
■ IEEE 802.11h TPC, Spectrum Measurement
■ IEEE 802.11k Radio Resource Measurement
■ IEEE 802.11i (WPA, WPA2). Open, shared
key, and pair-wise key authentication
services
■ Cisco Compatible Extensions (CCX) for
WLAN devices
MAC Features
■ Frame aggregation for increased MAC
efficiency (A-MSDU, A-MPDU)
■ Low latency immediate High-Throughput
Block Acknowledgement (HT-BA)
■ Long NAV for media reservation with
CF-End for NAV release
■ PHY-level spoofing to enhance legacy
compatibility
■ MIMO power saving mechanism
■ Channel management and co-existence
■ Multiple BSSID feature allows the
RTL8192SE to assume multiple MAC
identities when used as a wireless bridge
■ Supports Wake-On-WLAN via Magic
Packet and Wake-up frame
■ Transmit Opportunity (TXOP) Short
Inter-Frame Space (SIFS) bursting for higher
multimedia bandwidth
Peripheral Interfaces
■ General Purpose Input/Output (8 pins)
■ 4-wire EEPROM control interface (93C46)
■ Two configurable LED pins
■ Configurable Bluetooth Coexistence
Interface
PHY Features
■ IEEE 802.11n draft 2.0 MIMO OFDM
■ Two Transmit and Two Receive path (2T2R)
■ 20MHz and 40MHz bandwidth transmission
■ Short Guard Interval (400ns)
■ Sounding packet
■ DSSS with DBPSK and DQPSK, CCK
modulation with long and short preamble
■ OFDM with BPSK, QPSK, 16QAM, and
64QAM modulation.
Convolutional Coding Rate: 1/2, 2/3, 3/4,
and 5/6
■ Maximum data rate 54Mbps in 802.11g and
300Mbps in 802.11n
■ OFDM receive diversity with MRC using up
to 2 receive paths. Switch diversity used for
DSSS/CCK.
■ Hardware antenna diversity
■ Selectable digital transmit and receiver FIR
filters
■ Programmable scaling in transmitter and
receiver to trade quantization noise against
increased probability of clipping
■ Fast receiver Automatic Gain Control (AGC)
■ On-chip ADC and DAC
|