Qdatasheet_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

NE1617ADS,112

  

Datasheet PDF - NXP Semiconductors.

NE1617ADS,112 image

Part Name
NE1617ADS,112

Other PDF
  2009  

PDF

page
30 Pages

File Size
229.7 kB

MFG CO.
NXP
NXP Semiconductors. 

General description
The NE1617A is an accurate two-channel temperature monitor. It measures the temperature of itself and the temperature of a remote sensor. The remote sensor is a diode connected transistor. This can be in the form of either a discrete NPN/PNP, such as the 2N3904/2N3906, or a diode connected PNP built into another die, such as is done on some Intel microprocessors.
The temperature of both the remote and local sensors is stored in a register that can be read via a 2-wire SMBus. The temperatures are updated at a rate that is programmable via the SMBus (the average supply current is dependent upon the update rate — the faster the rate, the higher the current).
In addition to the normal operation, which is to update the temperature at the programmed rate, there is a one-shot mode that will force a temperature update.
There is also an alarm that senses either an overtemperature or undertemperature condition. The trip points for this alarm are also programmable.
The device can have one of nine addresses (determined by two address pins), so there can be up to nine of the NE1617A on the SMBus.
It can also be put in standby mode (in order to save power). This can be done either with software (over the SMBus) or with hardware (using the STBY pin).

Features and benefits
■ Replacement for Maxim MAX1617 and Analog Devices ADM1021
■ Monitors local and remote temperature
■ Local (on-chip) sensor accuracy:
 ♦ ±2 °C at 60 °C to 100 °C
 ♦ ±3 °C at -40 °C to 125 °C
■ Remote sensor accuracy:
 ♦ ±3 °C at 60 °C to 100 °C
 ♦ ±5 °C at -40 °C to 125 °C
■ No calibration required
■ Programmable overtemperature/undertemperature alarm
■ SMBus 2-wire serial interface up to 100 kHz
■ 3 V to 5.5 V supply range; 5.5 V tolerant
■ 70 μA supply current in operating mode
■ 3 μA (typical) supply current in standby mode
■ ESD protection exceeds 2000 V HBM per JESD22-A114 and 1000 V CDM per JESD22-C101
■ Latch-up testing is done to JEDEC standard JESD78, which exceeds 100 mA
■ Small 16-lead SSOP (QSOP) package

Applications
■ Desktop computers
■ Notebook computers
■ Smart battery packs
■ Industrial controllers
■ Telecommunications equipment


Part Name
Description
PDF
MFC CO.
Temperature monitor for microprocessor systems
Philips Electronics
Temperature monitor for microprocessor systems
Philips Electronics
Temperature monitor for microprocessor systems
Philips Electronics
Evaluation Board for Microprocessor System Temperature Monitor
Analog Devices
Low-Cost Microprocessor System Temperature Monitor
Analog Devices
Low Cost Microprocessor System Temperature Monitor
Analog Devices
Microprocessor Monitor
Maxim Integrated
MICROPROCESSOR MONITOR
TelCom Semiconductor Inc => Microchip
Microprocessor Monitor ( Rev : 1991 )
Maxim Integrated
Microprocessor Monitor
ON Semiconductor

Share Link: 


All Rights Reserved © qdatasheet.com [ Privacy Policy ] [ Contact Us ]