AAT3119IJS-5.0-T1 View Datasheet(PDF) - Analog Technology Inc
Part Name
Description
MFG CO.
'AAT3119IJS-5.0-T1' PDF : 16 Pages View PDF
AAT3119
High Efficiency 2X Charge Pump
CFLY
1µF
V
IN
IN
CIN
1µF
OUT
4.5V
COUT
1µF
AAT3119
Enable
EN
RL
GND
Flash Enable
Flash LED
RF
Figure 3: Flash LED Driver with Gated Flash Application.
Layout Considerations
For the AAT3119, the high charge pump switching
frequencies and large peak transient currents
require careful printed circuit board layout. As a
general rule for charge pump boost converters, the
three external capacitors should be located as
closely as possible to the device package with min-
imum length trace connections. Maximize ground
plane around the AAT3119 charge pump and make
sure all external capacitor are connected to the
immediate power ground plane. A local component
side ground plane is recommended. If this is not
possible due the layout area limitations, assure
good ground connections by the use of large or
multiple printed circuit board vias.
Refer to the following basic AAT3119 evaluation
board shown in Figures xxx for an example of the
recommended charge pump layout design.
3119.2005.08.1.1
15
Share Link: 
