ACS704ELC-015 View Datasheet(PDF) - Allegro MicroSystems
Part Name
Description
MFG CO.
ACS704ELC-015
Allegro MicroSystems
'ACS704ELC-015' PDF : 20 Pages View PDF
ACS704ELC-015
Applications Information
Transient Common-Mode Voltage Rejection in the ACS704
In order to quantify transient common-mode voltage rejection for the ACS704, a device was soldered onto a printed
circuit board. A 0.1 μF bypass capacitor and a 5 V dc power supply were connected between VCC and GND (pins 8 and
5) for this device. A 10 kΩ load resistor and a 0.01 μF capacitor were connected in parallel between the VOUT pin and
the GND pin of the device (pins 7 and 5).
1
8
Vcc
V1
VOUT=0V
VOUT=20VPP
freq=variable
2
7 Output
C0
V0
IP
C=0.1µF
VDC=5V
3
6
C3
C=0.01µF
R=10kΩ
R0
4
5
Ground
GND
ACS704 Schematic Diagram of the Circuit used to Measure Transient Rejection
A function generator was connected between the primary current conductor (pins 1 thru 4) and the GND pin of
the device (pin 5). This function generator was configured to generate a 10 V peak (20 V peak-to-peak) sine
wave between pins 1-4 and pin 5. Note that the sinusoidal stimulus was applied such that no electrical current
would flow through the copper conductor composed of pins 1-4 of this device.
The frequency of this sine wave was varied from 60 Hz to 5 MHz in discrete steps. At each frequency, the
statistics feature of an oscilloscope was used to measure the voltage variations (noise) on the ACS704 output
in mV (peak to peak). The noise was measured both before and after the application of the stimulus. Transient
common-mode voltage rejection as a function of frequency is shown in the following figure.
–30
–35
–40
–45
–50
–55
–60
0.06
1 10 100 300 600 800 1000 3000 5000
Frequency of 20 V Peak-to-Peak Stimulus (kHz)
ACS704ELC015-DS, Rev. 6
16
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com
Share Link: 