ACS8525A View Datasheet(PDF) - Semtech Corporation
Part Name
Description
MFG CO.
'ACS8525A' PDF : 112 Pages View PDF
ACS8525A LC/P
ADVANCED COMMS & SENSING
FINAL
DATASHEET
Figure 6 DPLL1 Jitter Transfer Characteristic, (Freq = 1.544 MHz, Jitter = 0.2 UI p-p, Damping Factor = 5)
F8525D_005WANJITTXFR_02bitmap.bmp
Damping Factor Programmability
The DPLL damping factor is set by default to provide a
maximum wander gain peak of around 0.1 dB. Many of
the specifications (e.g. GR-1244-CORE [13], G.812[7] and
G.813[8]) specify a wander transfer gain of less than
0.2 dB. GR-253[11] specifies jitter (not wander) transfer of
less than 0.1 dB. To accommodate the required levels of
transfer gain, the ACS8525A provides a choice of
damping factors, with more choice given as the
bandwidth setting increases into the frequency regions
classified as jitter. Table 5 shows which damping factors
are available for selection at the different bandwidth
settings, and what the corresponding jitter transfer
approximate gain peak will be.
Phase/Frequency/Lock Detection
Two main types of detector are used in the ACS8525A:
z Phase and frequency detectors, and
z Phase Loss/Lock detectors.
Phase and Frequency Detectors
There are two multi-phase and frequency detectors, one
for each DPLL. The multi-phase and frequency detectors
are used to compare input and feedback clocks. They
operate at input frequencies up to 77.76 MHz. DPLL1 can
lock to input spot frequencies from 2 kHz up to
77.76 MHz (155.52 MHz is internally divided down to
77.76 MHz). A common arrangement however is to use
Lock8k mode (See Bit 6 of Reg. 22 to Reg. 28), where all
input frequencies are divided down to 8 kHz internally.
Marginally better MTIE figures may be possible in direct
lock mode due to more regular phase updates. This direct
locking capability is one of the unique features of the
ACS8525A.
A patented multi-phase detector is used in order to give
an infinitesimally small input phase resolution combined
with large jitter tolerance. A multi-phase detector
comprises the following phase detectors:
z Phase and frequency detector (±360°or ±180°
range)
Revision 1.00/September 2007 © Semtech Corp.
Page 18
www.semtech.com
Share Link: 
