APM1950-P29 View Datasheet(PDF) - ASB Inc
Part Name
Description
MFG CO.
'APM1950-P29' PDF : 6 Pages View PDF
Application Circuit
C1
IN
plerowTM APM1950-P29
Low Noise & High OIP3
Medium Power Amplifier Module
VS
+-
Tantal or MLC (Multi Layer Ceramic)
Capacitor
C2
APM
OUT
1) The tantal or MLC (Multi Layer Ceramic) capacitor is optional and for bypassing the AC noise introduced
from the DC supply. The capacitance value may be determined by customer’s DC supply status. The ca-
pacitor should be placed as close as possible to Vs pin and be connected directly to the ground plane for
the best electrical performance.
2) DC blocking capacitors are always necessarily placed at the input and output port for allowing only the
RF signal to pass and blocking the DC component in the signal. The DC blocking capacitors are in-
cluded inside the APM module. Therefore, C1 & C2 capacitors may not be necessary, but can be added
just in case that the customer wants. The value of C1 & C2 is determined by considering the application
frequency.
Recommended Soldering Reflow Process
260°C
Ramp-up
(3˚C/sec)
200°C
20~40 sec
Ramp-down
IN
(6°C/sec)
Vs
OUT
150°C
60~180 sec
Size 40x40mm
(for APM Series – 13x13mm)
5/6
www.asb.co.kr
February 2009
Share Link: 
