AT24C16D-PHM View Datasheet(PDF) - Atmel Corporation
Part Name
Description
MFG CO.
'AT24C16D-PHM' PDF : 27 Pages View PDF
3.5 Software Reset
After an interruption in protocol, power loss, or system reset, any 2-Wire part can be protocol reset by following
these steps:
1. Create a Start condition (if possible).
2. Clock nine cycles.
3. Create another Start condition followed by a Stop condition as seen in Figure 3-2.
The device should be ready for the next communication after above steps have been completed. In the event
that the device is still non-responsive or remains active on the SDA bus, a power cycle must be used to reset
the device (see Section 8.5.1, “Device Reset”).
Figure 3-2. Software Reset
Dummy Clock Cycles
SCL
1
2
3
Start
Condition
SDA
8
9
Start
Condition
Stop
Condition
6
AT24C16D [DATASHEET]
Atmel-8906C-SEEPROM-AT24C16D-Datasheet_052015
Share Link: 
