C8051F362-GM2 View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
MFG CO.
'C8051F362-GM2' PDF : 288 Pages View PDF
C8051F360/1/2/3/4/5/6/7/8/9
The Digital Crossbar allows mapping of internal digital system resources to Port I/O pins. (See Figure 1.8.)
On-chip counter/timers, serial buses, HW interrupts, comparator output, and other digital signals in the
controller can be configured to appear on the Port I/O pins specified in the Crossbar Control registers. This
allows the user to select the exact mix of general purpose Port I/O and digital resources needed for the
particular application.
Highest
Priority
Lowest
Priority
2
UART
4
SPI
2
SMBus
CP0
4
CP1
Outputs
SYSCLK
PCA
7
2
T0, T1
8
P0 (P0.0-P0.7)
8
P1 (P1.0-P1.7)
8
P2 (P2.0-P2.7)
8
P3 (P3.0-P3.7)
XBR0, XBR1,
PnSKIP Registers
P0MASK, P0MATCH
P1MASK, P1MATCH,
P2MASK, P2MATCH
Registers
Priority
Decoder
8
Digital
8
Crossbar
8
8
PnMDOUT,
PnMDIN Registers
P0
I/O
Cells
P1
I/O
Cells
P2
I/O
Cell
P3
I/O
Cells
P0.0
P0.7
P1.0
P1.7
P2.0
P2.7
P3.0
P3.7
3.1–3.4 available on
C8051F360/1/3/4/6/8
3.5–3.7 available on
C8051F360/3
Figure 1.8. Digital Crossbar Diagram (Port 0 to Port 3)
1.5. Serial Ports
The C8051F36x Family includes an SMBus/I2C interface, a full-duplex UART with enhanced baud rate
configuration, and an Enhanced SPI interface. Each of the serial buses is fully implemented in hardware
and makes extensive use of the CIP-51's interrupts, thus requiring very little CPU intervention.
1.6. Programmable Counter Array
An on-chip Programmable Counter/Timer Array (PCA) is included in addition to the four 16-bit general pur-
pose counter/timers. The PCA consists of a dedicated 16-bit counter/timer time base with three program-
mable capture/compare modules. The PCA clock is derived from one of six sources: the system clock
divided by 12, the system clock divided by 4, Timer 0 overflows, an External Clock Input (ECI), the system
clock, or the external oscillator clock source divided by 8. The external clock source selection is useful for
26
Rev. 1.0
Share Link: 
