C8051T603 View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
MFG CO.
'C8051T603' PDF : 168 Pages View PDF
C8051T600/1/2/3/4/5/6
Note that false rising edges and falling edges can be detected when the comparator is first powered on or
if changes are made to the hysteresis or response time control bits. Therefore, it is recommended that the
rising-edge and falling-edge flags be explicitly cleared to logic 0 a short time after the comparator is
enabled or its mode bits have been changed.
SFR Definition 13.1. CPT0CN: Comparator0 Control
Bit
Name
Type
Reset
7
CP0EN
R/W
0
6
CP0OUT
R
0
5
CP0RIF
R/W
0
4
CP0FIF
R/W
0
3
2
CP0HYP[1:0]
R/W
0
0
1
0
CP0HYN[1:0]
R/W
0
0
SFR Address = 0xF8; Bit-Addressable
Bit
Name
Function
7
CP0EN Comparator0 Enable Bit.
0: Comparator0 Disabled.
1: Comparator0 Enabled.
6 CP0OUT Comparator0 Output State Flag.
0: Voltage on CP0+ < CP0–.
1: Voltage on CP0+ > CP0–.
5
CP0RIF Comparator0 Rising-Edge Flag. Must be cleared by software.
0: No Comparator0 Rising Edge has occurred since this flag was last cleared.
1: Comparator0 Rising Edge has occurred.
4
CP0FIF Comparator0 Falling-Edge Flag. Must be cleared by software.
0: No Comparator0 Falling-Edge has occurred since this flag was last cleared.
1: Comparator0 Falling-Edge has occurred.
3:2 CP0HYP[1:0] Comparator0 Positive Hysteresis Control Bits.
00: Positive Hysteresis Disabled.
01: Positive Hysteresis = 5 mV.
10: Positive Hysteresis = 10 mV.
11: Positive Hysteresis = 20 mV.
1:0 CP0HYN[1:0] Comparator0 Negative Hysteresis Control Bits.
00: Negative Hysteresis Disabled.
01: Negative Hysteresis = 5 mV.
10: Negative Hysteresis = 10 mV.
11: Negative Hysteresis = 20 mV.
Rev. 1.2
61
Share Link: 
