CC2430F64RTC View Datasheet(PDF) - TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS
Part Name
Description
MFG CO.
CC2430F64RTC
TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS
'CC2430F64RTC' PDF : 212 Pages View PDF
CC2430
Peripherals : I/O ports
PICTL (0x8C) – Port Interrupt Control
Bit Name
7-
6 PADSC
5 P2IEN
4 P0IENH
3 P0IENL
2 P2ICON
1 P1ICON
0 P0ICON
Reset R/W
0
R0
0
R/W
0
R/W
0
R/W
0
R/W
0
R/W
0
R/W
0
R/W
Description
Not used
Drive strength control for I/O pins in output mode. Selects output
drive capability to account for low I/O supply voltage on pin DVDD
(this to ensure same drive strength at lower voltages as is on
higher).
0 Minimum drive capability. DVDD equal or greater than 2.6V
1 Maximum drive capability. DVDD less than 2.6V
Port 2, inputs 4 to 0 interrupt enable. This bit enables interrupt
requests for the port 2 inputs 4 to 0.
0 Interrupts are disabled
1 Interrupts are enabled
Port 0, inputs 7 to 4 interrupt enable. This bit enables interrupt
requests for the port 0 inputs 7 to 4.
0 Interrupts are disabled
1 Interrupts are enabled
Port 0, inputs 3 to 0 interrupt enable. This bit enables interrupt
requests for the port 0 inputs 3 to 0.
0 Interrupts are disabled
1 Interrupts are enabled
Port 2, inputs 4 to 0 interrupt configuration. This bit selects the
interrupt request condition for all port 2 inputs
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
Port 1, inputs 7 to 0 interrupt configuration. This bit selects the
interrupt request condition for all port 1 inputs
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
Port 0, inputs 7 to 0 interrupt configuration. This bit selects the
interrupt request condition for all port 0 inputs
0 Rising edge on input gives interrupt
1 Falling edge on input gives interrupt
P1IEN (0x8D) – Port 1 Interrupt Mask
Bit Name
Reset R/W
7:0 P1_[7:0]IEN 0x00 R/W
Description
Port P1_7 to P1_0 interrupt enable
0 Interrupts are disabled
1 Interrupts are enabled
CC2430 Data Sheet (rev. 2.1) SWRS036F
Page 87 of 211
Share Link: 