CHR2244-QDG21 View Datasheet(PDF) - United Monolithic Semiconductors
Part Name
Description
MFG CO.
'CHR2244-QDG21' PDF : 14 Pages View PDF
5.8 GHz One Antenna Reflective Tag
CHR2244
Design Recommendations
n All of the different inputs (TR, Mod) and outputs (SB_out, DATA_out) should be properly isolated
(separated enough or with a ground path between them).
n As TR port is the most sensitive one, a specific circuit (see on diagram) can be used for high level of
isolation.
n Device slug should be connected to RF ground plane through multiples vias (>=9).
n An external matching may be required to optimize RF performances on 50Ω impedance, versus
substrate height. A RF ground plane height of 0.008” (0.203mm) under the component (evaluation
board) provides the highest RF performances thanks to low RF ground inductance and low pin to pin
coupling.
Adjustment abilities:
Pin number Pin name Component
Description
Standby sensitivity adjust port :
7
SENS
R3
A value lower than 2.2MΩ decreases Standby chain
sensitivity.
Standby amplifiers Gain adjust port :
12
Ga_SB
R4
A value lower than 680kΩ increases Standby chain
sensitivity.
Downlink threshold adjust port :
19
Ad
R5
A value lower than 6.8MΩ decreases Downlink chain
sensitivity.
Downlink amplifiers Gain adjust port :
20
Ga_WK
R6
A value lower than 220 kΩ increases Downlink chain
sensitivity.
IMPORTANT NOTICE :
All this adjustments may cause non linear response of the performances versus resistors values. The
sensitivity is –1x(Minimum RF power for considered mode).
Ref. : DSCHR2244QDG5053 - 22 Feb 05
7/16
Specifications subject to change without notice
Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE
Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09
Share Link: 
