CS89712 View Datasheet(PDF) - Cirrus Logic
Part Name
Description
MFG CO.
'CS89712' PDF : 170 Pages View PDF
CS89712
2.25.3 LED Connection
Each LED output is capable of sinking 10 mA to
drive an LED directly through a series resistor. The
output voltage of each pin is less than 0.4 V when
the pin is low.
2.26 Media Access Control Engine
2.26.1 Overview
The CS89712’s Ethernet Media Access Control
(MAC) engine is fully compliant with the IEEE
802.3 Ethernet standard (ISO/IEC 8802-3, 1993). It
handles all aspects of Ethernet frame transmission
and reception, including: collision detection, pre-
amble generation and detection, and CRC genera-
tion and test. Programmable MAC features include
automatic retransmission on collision, and padding
of transmitted frames. The primary functions of the
MAC are: frame encapsulation and decapsulation;
error detection and handling; and, media access
management.
2.26.2 Frame Encapsulation/Decapsulation
The Ethernet port’s MAC engine automatically as-
sembles transmit packets and disassembles receive
packets. It also determines if transmit and receive
frames are of legal minimum size.
2.26.2.1 Transmission
Once the proper number of bytes have been trans-
ferred to the Ethernet port’s memory (either 5, 381,
1021 bytes, or full frame), and providing that ac-
cess to the network is permitted, the MAC automat-
ically transmits the 7-byte preamble (1010101b...),
followed by the Start-of-Frame Delimiter (SFD,
10101011b), and then the serialized frame data. It
then transmits the Frame Check Sequence (FCS).
The data after the SFD and before the FCS (Desti-
nation Address, Source Address, Length, and data
field) is supplied by the software. FCS generation
by the Ethernet port may be disabled by setting the
InhibitCRC bit (TxCMD register, bit C).
Figure 13 shows the Ethernet frame format.
2.26.2.2 Reception
The MAC receives the incoming packet as a serial
stream of NRZ data from the Manchester encod-
er/decoder. It begins by checking for the SFD.
Once the SFD is detected, the MAC assumes all
subsequent bits are frame data. It reads the DA and
compares it to the criteria programmed into the ad-
dress filter (see Section 2.32.7, “Receive Ethernet
Port Locations” for a description of Address Filter-
ing). If the DA passes the address filter, the frame
is loaded into the Ethernet port’s memory. If the
BufferCRC bit (RxCFG register, bit B) is set, the
received FCS is also loaded into memory. Once the
entire packet has been received, the MAC validates
the FCS. If an error is detected, the CRCerror bit
(RxEvent register, Bit C) is set.
up to 7 bytes
1 byte
alternating 1s / 0s SFD
Packet
6 bytes
6 bytes
DA
SA
Frame
2 bytes
4 bytes
Length Field LLC data Pad FCS
preamble
Direction of Transmission
frame length
min 64 bytes
max 1518 bytes
SFD = Start of Frame Delimiter
DA = Destination Address
SA = Source Address
LLC = Logical Link Control
FCS = Frame Check Sequence (also
called Cyclic Redundancy Check, or CRC)
Figure 13. Ethernet Frame Format
DS502PP2
47
Share Link: 
