Qdatasheet_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

DS1882 View Datasheet(PDF) - Maxim Integrated

Part Name
Description
MFG CO.
DS1882
MaximIC
Maxim Integrated MaximIC
'DS1882' PDF : 15 Pages View PDF
1 2 3 4 5 6 7 8 9 10 Next
Dual Log Audio Digital Potentiometer
NV MEMORY CHARACTERISTICS
(VDD = +4.5V to +5.5V, VCC = +4.5V to +7.0V, V- = -4.5V to -7.0V, TA = 0°C to +70°C.)
Writes
PARAMETER
SYMBOL
CONDITIONS
+70°C (Note 6)
MIN TYP
50,000
MAX UNITS
Note 1: All voltages are referenced to ground.
Note 2: The value of VDD should never exceed VCC, including during power-ups. VCC must be applied before VDD.
Note 3: IDD is specified with SDA = SCL = CE = VDD, resistor pins floating, and digital inputs connected to VDD or GND.
Note 4: ICC is specified with SDA = SCL = CE = VDD, resistor pins floating, and digital inputs connected to VDD or GND, after zero-
crossing detection has timed out.
Note 5: The DS1882 will not obstruct the SDA and SCL lines if VDD is switched off as long as the voltages applied to these inputs
do not violate their minimum and maximum input voltage levels.
Note 6: Guaranteed by design.
Note 7: Above Position 50, these are typical maximum. Guaranteed by characterization.
Note 8: Load is representative of the input of a low-noise audio amp.
Note 9: Timing shown is for fast-mode (400kHz) operation. This device is also backward-compatible with I2C standard-mode timing.
Note 10: CBTotal capacitance of one bus line in picofarads.
Note 11: If zero-crossing detection is enabled, the EEPROM write does not begin until the current zero-crossing detection is com-
plete. Otherwise, EEPROM write begins after a STOP condition occurs.
(VDD = VCC = +5.0V, V- = -5.0V, TA = +25°C.)
Typical Operating Characteristics
POTENTIOMETER 0 (CONFIGURATON 1)
ATTENUATION vs. SETTING
0
POTENTIOMETER 0 (CONFIGURATON 2)
ATTENUATION vs. SETTING
0
POTENTIOMETER 1 (CONFIGURATON 1)
ATTENUATION vs. SETTING
0
-20.0
-20.0
-20.0
-40.0
-40.0
-40.0
-60.0
-60.0
-60.0
-80.0
-80.0
-80.0
-100.0
0
9 18 27 36 45 54 63
SETTING (DEC)
-100.0
0 3 6 9 12 15 18 21 24 27 30 33
SETTING (DEC)
-100.0
0
9 18 27 36 45 54 63
SETTING (DEC)
4 _____________________________________________________________________
Share Link: GO URL

All Rights Reserved © qdatasheet.com  [ Privacy Policy ] [ Contact Us ]