EVAL-ADV7183BEB View Datasheet(PDF) - Analog Devices
Part Name
Description
MFG CO.
'EVAL-ADV7183BEB' PDF : 104 Pages View PDF
Manual Input Muxing
By accessing a set of manual override muxing registers, the
analog input muxes of the ADV7183A can be controlled
directly. This is referred to as manual input muxing.
Notes
• Manual input muxing overrides other input muxing
control bits, for example, INSEL.
• The manual muxing is activated by setting the
ADC_SW_MAN_EN bit. It affects only the analog
switches in front of the ADCs.
This means if the settings of INSEL and the manual input
muxing registers (ADC0/ADC1/ADC2_sw) contradict
each other, the ADC0/ADC1/ADC2_sw settings apply and
INSEL is ignored.
ADV7183A
• Manual input muxing only controls the analog input
muxes. INSEL[3:0] still has to be set so the follow-on
blocks process the video data in the correct format.
This means INSEL must still be used to tell the ADV7183A
whether the input signal is of component, YC, or CVBS
format.
Restrictions in the channel routing are imposed by the analog
signal routing inside the IC; every input pin cannot be routed to
each ADC. Refer to Figure 6 for an overview on the routing
capabilities inside the chip. The three mux sections can be
controlled by the reserved control signal buses ADC0/ADC1/
ADC2_sw[3:0]. Table 10 explains the control words used.
SETADC_sw_man_en, Manual Input Muxing Enable,
Address 0xC4 [7]
ADC0_sw[3:0], ADC0 mux configuration, Address 0xC3 [3:0]
ADC1_sw[3:0], ADC1 mux configuration, Address 0xC3 [7:4]
ADC2_sw[3:0], ADC2 mux configuration, Address 0xC4 [3:0]
Table 10. Manual Mux Settings for All ADCs
SETADC_sw_man_en = 1
ADC0_sw[3:0] ADC0 Connected To: ADC1_sw[3:0] ADC1 Connected To:
0000
No Connection
0000
No Connection
0001
AIN1
0001
No Connection
0010
AIN2
0010
No Connection
0011
AIN3
0011
AIN3
0100
AIN4
0100
AIN4
0101
AIN5
0101
AIN5
0110
AIN6
0110
AIN6
0111
No Connection
0111
No Connection
1000
No Connection
1000
No Connection
1001
AIN7
1001
No Connection
1010
AIN8
1010
No Connection
1011
AIN9
1011
AIN9
1100
AIN10
1100
AIN10
1101
AIN11
1101
AIN11
1110
AIN12
1110
AIN12
1111
No Connection
1111
No Connection
ADC2_sw[3:0]
0000
0001
0010
0011
0100
0101
0110
0111
1000
1001
1010
1011
1100
1101
1110
1111
ADC2 Connected To:
No Connection
No Connection
AIN2
No Connection
No Connection
AIN5
AIN6
No Connection
No Connection
No Connection
AIN8
No Connection
No Connection
AIN11
AIN12
No Connection
Rev. B | Page 15 of 104
Share Link: 
