FS6370 View Datasheet(PDF) - Unspecified
Part Name
Description
MFG CO.
'FS6370' PDF : 25 Pages View PDF
FS6370-01
EEPROM Programmable 3-PLL Clock Generator IC
13.1 Demo Kit Contents
• Demonstration board
• Interface cable (DB25 to 6-pin connector)
• Data sheet
• Demonstration software, totaling 24 compressed
files which will expand to 1.8MB, including
fs6370.exe after installation.
13.2 Requirements
• PC running MS Windows 3.1x or 95/98 with an ac-
cessible parallel (LPT1) port. Software also runs on
Windows NT in a calculation mode only.
• 1.8MB available space on hard drive C.
13.3 Board Setup and Software
Installation Instructions
1. At the appropriate disk drive prompt (A:\) unzip the
compressed demo files to a directory of your choice.
Run setup.exe to install the software.
2. Connect a power supply to the board: RED = power,
BLACK = ground.
3. Connect the supplied interface cable to the parallel
port (DB25 connector) and to the demo board (6-pin
connector). Make sure the cable is facing away from
the board. Pin 1 is the red wire per Table 20.
4. Connect the clock outputs to the target application
board with a twisted-pair cable.
13.4 Demo Program Operation
Launch the fs6370.exe program. Note that the
parallel port can not be accessed if your machine
is running Windows NT. A warning message will
appear stating: “This version of the demo program cannot
communicate with the FS6370 hardware when running
on a Windows NT operating system. Do you want to con-
tinue anyway, using just the calculation features of this
program?” Clicking OK starts the program for calculation
only.
The opening screen is shown in Figure 15.
Figure 15: Opening Screen
23
Share Link: 
