FX375J View Datasheet(PDF) - CML Microsystems Plc
Part Name
Description
MFG CO.
'FX375J' PDF : 11 Pages View PDF
CML Semiconductor Products
PRODUCT INFORMATION
FX375 Private Squelch Circuit
Features
Tone Operated Private/Clear
Switching
CTCSS Tone Encode/Decode
Separate Rx/Tx Speech Paths
Fixed Frequency Speech Inversion
µP Compatible Interface with Serial
or Parallel Control Loading
Publication D/375/4 July 1994
On-Chip Pre- and De-Emphasis
Filtering in the Tx Path
38 Programmable Tones
+ 'NoTone' Facility
Audio Path Filtering
(300Hz – 3033Hz)
Low Power 5V CMOS
Tx
Tx
Tx AUDIO INPUT
6dB/OCTAVE
BIAS
Rx
f EMPH
FILTER
OUTPUT
fCLK1
BALANCED CLEAR
MODULATOR
INPUT
fCARRIER
f CLK2
– 6dB/OCTAVE
Rx
f EMPH
Tx
PRIVATE
Tx AUDIO OUTPUT
BIAS
Rx AUDIO INPUT
Rx AUDIO OUTPUT
XTAL
XTAL
Rx TONE INPUT
LOAD/LATCH
D5 or SERIAL ENABLE 1
D4 or SERIAL ENABLE 2
D3 or SERIAL DATA INPUT
D2 or SERIAL CLOCK INPUT
D 1 INPUT
D0 I N P U T
Rx/Tx
CONTROL
PRIVATE ENABLE
CLOCKS
3333Hz
FILTERS
REFERENCE
CTCSS
TONE
DETECT
+ HYSTERESIS
–
3333Hz
8-BIT
SHIFT
REGISTER
AND
LATCHES
LD 5
LD0
CONTROL
PRESS TO LISTEN
Fig.1 Internal Block Diagram
Rx TONE DECODER OUTPUT
DECODE COMPARATOR INPUT
Rx TONE DETECT OUTPUT
LOGIC
PTL
TX
TONE
OUTPUT
NOTONE OUTPUT
f CARRIER
f CLK1
f CLK2
f EMPH
Rx PATH
VDD
VBIAS
Tx PATH
PRIVATE
VSS
FX375
Brief Description
The FX375 is a Low-Power CMOS LSI microcircuit
designed for Tone Operated Voice Privacy in
communication systems.
This half-duplex device consists of a Fixed Frequency
Voice Band Inverter interfaced with a Continuous Tone
Controlled Squelch System (CTCSS) Encoder/
Decoder, whose allocated tone is used for voice
privacy and audio squelch operation.
Frequency Inversion is achieved by modulating the
input audio with a fixed carrier frequency to exchange
the high and low frequencies of the voice band, making
the resulting audio output unintelligible to receivers not
equipped with a compatible system.
The on-chip CTCSS Dencoder is capable of encoding
and decoding any one of 38 sub-audio tones in the
range 67.0Hz to 250.3Hz, these Xtal derived tones are
selected by a 6-bit binary word that can be loaded to
the device in either a serial or parallel format.
The Privacy function is exclusive only to units using the
same tone set, other intercepted signals remain "as
transmitted."
A 'Press to Listen' facility allows monitoring of the
channel prior to transmitting.
This device has separate, switched Rx and Tx voice,
and tone audio paths. Voice paths use switched
capacitor bandpass filters for the attenuation of sub-
audio tones and unwanted modulation products.
6dB/octave pre- and de-emphasis filtering in the Tx
path maintains natural sounding audio from this device
when embodied in communication transceivers.
The FX375, which is available in DIL and SMT
packages, can be simply controlled by switches, or
interfaced to a µProcessor.
External requirements are a single 5-volt supply, an
external 4.0MHz Xtal or clock input and signal coupling
components.
Share Link: 
