GL852G-HHGXX View Datasheet(PDF) - Genesys Logic
Part Name
Description
MFG CO.
'GL852G-HHGXX' PDF : 38 Pages View PDF
GL852G Datasheet
5.1.11.2 Connected to USB 2.0 Host/Hub
If an USB 2.0 hub is connected to an USB 2.0 host/hub, it will operate in USB 2.0 mode. The upstream port
signaling is in high speed with bandwidth of 480 Mbps under this environment. The traffic channel will
then be routed to the REPEATER when the device connected to the downstream port is signaling also in
high speed. On the other hand, the traffic channel will then be routed to TT when the device connected to
the downstream port is signaling in full/low speed.
USB 2.0 HOST/HUB
USPORToperating
in HS signaling
HS vs. HS:
Traffic channel is
routed to REPEATER
REPEATER
TT
TT
HS vs. FS/LS:
Traffic channel
is routed to TT
DSPORT operating
in HS signaling
DSPORT operating
in FS/LS signaling
Figure 5.2 - Operating in USB 2.0 Schemes
5.1.12 DSPORT Logic
DSPORT (downstream port) logic implements the control logic defined in section 11.5 of USB specification
Revision 2.0. It mainly manipulates the state machine, the connection/disconnection detection, over current
detection and power enable control, and the status LED control of the downstream port. Besides, it also
output the control signals to the DSPORT transceiver.
5.1.13 DSPORT Transceiver
DSPORT transceiver is the analog circuit that supports high-speed, full-speed, and low-speed electrical
characteristics defined in chapter 7 of USB specification Revision 2.0. In addition, each DSPORT transceiver
accurately controls its own squelch level to detect the detachment and attachment of devices.
©2012 Genesys Logic, Inc. - All rights reserved.
Page 22
Share Link: 
