LM2903D/DT View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'LM2903D/DT' PDF : 18 Pages View PDF
LM2903
4
Electrical characteristics
Electrical characteristics
Table 3. VCC+ = 5 V, VCC- = GND, Tamb = 25°C (unless otherwise specified)
Symbol
Parameter
Min. Typ.
Max.
Unit
Vio
Input offset voltage(1)
Tmin ≤ Tamb ≤ Tmax
Iio
Input offset current
Tmin ≤ Tamb ≤ Tmax
Iib
Input bias current(2)
Tmin ≤ Tamb ≤ Tmax
Avd
Large signal voltage gain
VCC = 15 V, RL= 15 kΩ, Vo= 1 to 11 V
Supply current (all comparators)
ICC
VCC = 5 V, no load
VCC = 30 V, no load
Vid Differential input voltage(3)
VOL
Low level output voltage (Vid = -1 V, Isink = 4 mA)
Tmin ≤ Tamb ≤ Tmax
IOH
High level output current (VCC =Vo = 30 V, Vid = 1 V)
Tmin ≤ Tamb ≤ Tmax
Isink Output sink current (Vid = -1 V, Vo = 1.5 V)
tres Small signal response time(4) (RL = 5.1 kΩ to VCC+)
Large signal response time(5)
trel
TTL input (Vref = +1.4 V, RL= 5.1 kΩ to VCC+)
Output signal at 50 % of final value
Output signal at 95 % of final value
1
5
25
25 200
7
15
mV
50
150
nA
250
400
V/mV
0.4
1
mA
1
2.5
VCC+
V
250
400
700
mV
0.1
nA
1
µA
6
16
mA
1.3
µs
500
ns
1
µs
1.
At output switch point,
(0 V to VCC+ –1.5 V).
VO
≈
1.4 V, RS = 0 Ω with VCC+ from 5 V to 30 V, and over the full input common-mode range
2. The direction of the input current is out of the IC due to the PNP input stage. This current is essentially constant,
independent of the state of the output, so no loading charge exists on the reference of input lines.
3. Positive excursions of input voltage may exceed the power supply level. As long as the other voltage remains within the
common-mode range, the comparator provides a proper output state. The low input voltage state must not be less than
–0.3 V (or 0.3 V below the negative power supply, if used).
4. The response time specified is for a 100 mV input step with 5 mV overdrive.
5. Maximum values are guaranteed by design and evaluation.
Doc ID 2470 Rev 10
5/18
Share Link: 
