M41T56M6E_04 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'M41T56M6E_04' PDF : 25 Pages View PDF
M41T56
Output Driver Pin
When the FT Bit is not set, the FT/OUT pin be-
comes an output driver that reflects the contents of
D7 of the Control Register. In other words, when
D6 of location 7 is a '0' and D7 of location 7 is a '0'
and then the FT/OUT pin will be driven low.
Note: The FT/OUT pin is open drain which re-
quires an external pull-up resistor.
Initial Power-on Defaults
Upon initial application of power to the device, the
FT Bit will be set to a '0' and the OUT Bit will be set
to a '1.' All other Register bits will initially power-on
in a random state.
MAXIMUM RATING
Stressing the device above the rating listed in the
“Absolute Maximum Ratings” table may cause
permanent damage to the device. These are
stress ratings only and operation of the device at
these or any other conditions above those indicat-
ed in the Operating sections of this specification is
not implied. Exposure to Absolute Maximum Rat-
ing conditions for extended periods may affect de-
vice reliability. Refer also to the
STMicroelectronics SURE Program and other rel-
evant quality documents.
Table 4. Absolute Maximum Ratings
Symbol
Parameter
Value
Unit
TA
Ambient Operating Temperature
–40 to 85
°C
SNAPHAT
–40 to 85
TSTG
Storage Temperature (VCC Off, Oscillator Off)
°C
SOIC
–55 to 125
TSLD(1,2)
Lead Solder Temperature for 10 seconds
260
°C
VIO
Input or Output Voltages
–0.3 to 7
V
VCC
Supply Voltage
–0.3 to 7
V
IO
Output Current
20
mA
PD
Power Dissipation
0.25
W
Note: 1. For SO package, standard (SnPb) lead finish: Reflow at peak temperature of 225°C (total thermal budget not to exceed 180°C for
between 90 to 150 seconds).
2. For SO package, Lead-free (Pb-free) lead finish: Reflow at peak temperature of 260°C (total thermal budget not to exceed 245°C
for greater than 30 seconds).
CAUTION: Negative undershoots below –0.3V are not allowed on any pin while in the Battery Back-up mode.
CAUTION: Do NOT wave solder SOIC to avoid damaging SNAPHAT sockets.
14/24
Share Link: 
