MB90337PMC View Datasheet(PDF) - Fujitsu
Part Name
Description
MFG CO.
'MB90337PMC' PDF : 48 Pages View PDF
MB90335 Series
7. Stabilization of supply voltage
A sudden change in the supply voltage may cause the device to malfunction even within the VCC supply voltage
operating range. For stabilization reference, the supply voltage should be stabilized so that VCC ripple variations
(peak-to-peak value) at commercial frequencies (50 MHz to 60 MHz) fall below 10% of the standard VCC supply
voltage and the transient regulation does not exceed 0.1 V/ms at temporary changes such as power supply
switching.
8. Writing to flash memory
For serial writing to flash memory, always make sure that the operating voltage VCC is between 3.13 V and 3.6 V.
For normal writing to flash memory, always make sure that the operating voltage VCC is between 3.0 V and 3.6 V.
9. Serial communication
There is a possibility to receive wrong data due to noise or other causes on the serial communication. Therefore,
design a printed circuit board so as to avoid noise.
Consider receiving of wrong data when designing the system. For example, apply a checksum to detect an error.
If an error is detected, retransmit the data.
DS07-13735-6E
11
Share Link: 
