PCF85263ATL/A View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

MFG CO.

PCF85263ATL/A

Tiny Real-Time Clock/calendar with alarm function, battery switch-over, time stamp input, and I2C-bus

NXP Semiconductors. 

Prev 41 42 43 44 45 46 47 48 49 50 Next

NXP Semiconductors

PCF85263A

Tiny RTC with alarm, battery switch-over, and I2C-bus

When enabled, interrupts are triggered every time the battery switch circuit switches to

either battery or to VDD and even if the BSF is not cleared, an interrupt pulse can be

generated.

In addition, the INTA pin can be configured as a battery mode indicator

(INTAPM[1:0] = 00). See Section 8.12.6 on page 52. This mode differs from a general

interrupt signal in that it is only controlled by the current battery switch status.

See Section 8.9 on page 38 for interrupt control.

Remark: INTB pin is only active when the IC is operating from VDD.

8.12 Pin_IO register

Table 43.

Bit

Symbol

Section

Pin_IO- pin input output control register (address 27h) bit description

7

6

5

4

CLKPM

TSPULL

TSL

TSIM

Section 8.12.1 Section 8.12.2 Section 8.12.3 Section 8.12.5

3

2

TSPM[1:0]

Section 8.12.4

1

0

INTAPM[1:0]

Section 8.12.6

This register is used to define the input and output modes of the IC.

8.12.1 CLKPM: CLK pin mode control

Table 44. CLKPM bit - Pin_IO control register (address 27h)

Bit

Symbol

Value

Description

7

CLKPM[1]

CLK pin mode

0[2]

enable CLK pin

1

disable CLK pin

[1] CLK pin is not available on all package types.

[2] Default value.

Setting the CLKPM bit disables the CLK output and force the pin to drive out a logic 0.

Clearing this bit enables the pad to output the selected clock frequency (see bits COF[2:0]

in the Function register, see Table 51 on page 54).

8.12.2 TSPULL: TS pin pull-up resistor value

Table 45. TSPULL bit - Pin_IO control register (address 27h)

Bit

Symbol

Value

Description

6

TSPULL

TS pin pull-up resistor value

0[1]

80 k

1

40 k

[1] Default value.

Controls the pull-up resistor value used in the mechanical switch detector. For

applications where there is a large capacitance on the TS pin e.g. from a long connecting

cable to the mechanical switch, the pull-up resistor value can be halved to improve switch

detection.

Using the low-resistance value increases current consumption when the switch is closed

i.e. shorting to VSS.

PCF85263A

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 4.1 — 27 November 2015

© NXP Semiconductors N.V. 2015. All rights reserved.

50 of 100

Share Link: