PI3B16209A View Datasheet(PDF) - Pericom Semiconductor Corporation
Part Name
Description
MFG CO.
'PI3B16209A' PDF : 4 Pages View PDF
PI3B16209
3.3v, 18-Bit Bus Exchange NanoSwitchTM
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ....................................................... –65°C to +150°C
Ambient Temperature with Power Applied ........................ –0°C to +85°C
Supply Voltage Range........................................................ –0.5V to +4.6V
DC Input Voltage ............................................................... –0.5V to +4.6V
Note:
Stresses greater than those limited under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at
these or any other conditions above those indicated inthe op-
DC Output Current......................................................................... 120mA erational sections of this specification is not implied. Exposure
Power Dissipation .............................................................................. 1.0W to absolute maximum rating conditions for extended periods
may affect reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40˚C to +85˚C, VCC = 3.0V to 3.6V.)
Parameters
Description
Test Conditions(1)
Min. Typ(2) Max. Units
VIH
Input HIGH Voltage
Guarantee Logic HIGH Level
2.0
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
0.8
V
IIH
Input High Current
VCC = Max., VIN = VCC
±1
IIL
Input Low Current
VCC = Max., VIN = GND
±1
μA
IOZ
High Impedance Output Current 0 ≤ A, B, ≤ VCC
±1
VIK
Clamp Diode Voltage
VCC = Min., IIN = –18mA
RON
Switch ON Resistance(3)
VCC = Min., VIN = 0.0V ION = 48mA
VCC = Min., VIN = 2.4V ION = 15mA
–0.7 –1.2
V
5
8
Ω
10
15
Notes:
1. For Max. or Min. conditions, use appropriatr value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loafing.
3. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the lower of the
voltages on the two (A,B) pins.
Capacitance (TA = 25°C, f=1 MHz)
Parameters(1)
Descriptions
CIN
COFF
CON
Input Capacitance
A/B Capacitance, Switch Off
A/B Capacitance, Switch On
Test Conditions
VIN = 0V
Note:
1. This parameter is determined by device characterization but is not production tested.
Typ Units
3
14
pF
30
06-0221
2
PS8192J
02/13/07
Share Link: 
