PI3C32X384 View Datasheet(PDF) - Pericom Semiconductor

Part Name

Description

MFG CO.

PI3C32X384

2.5V/3.3V, High Bandwidth, Hot Insertion 20-Bit, 2-Port, Bus Switch

Pericom Semiconductor

'PI3C32X384' PDF : 4 Pages View PDF

1 2 3 4

PI3C32X384/PI3C32X2384 (25ohm)
2.5V/3.3V, High Bandwidth, Hot Insertion,
20-Bit, 2-Port BusSwitch 1122334455667788990011223344556677889900112233445566778899001122112233445566778899001122334455667788990011223344556677889900112211223344556677889900112233445566778899001122334455667788990011221122334455667788990011223344556677889900112233445566778899001122112233445566778899001122
Power Supply Characteristics
Parameters
Description
Test Conditions(1)
Min. Typ.(2) Max. Units
ICC
∆ICC
Quiescent Power Supply Current
VCC = Max.,
VIN = GND or VCC
PI3C32X384
PI3C32X2384

Supply Current per Input
@ TTL HIGH
VCC = Max.,
VIN = 3.0V(3)

0.50 1.0
mA
2.5
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device.
2. Typical values are at VCC = 3.3V, +25°C ambient.
3. Per TTL driven input (control inputs only); A and B pins do not contribute to ICC.
PI3C3384/PI3C32384 Switching Characteristics over 3.3V Operating Range
Parameters
Description
Conditions(1)
PI3C32X384
Com.
Units
Min. Max.
tPLH
tPHL
Propogation Delay(2,3) CL = 50pF
Ax to Bx, Bx to Ax RL = 500ohm

0.25
tPZH
tPZL
Bus Enable Time
BEx to Ax or Bx
CL = 50pF
1.5
6.5
ns
RL = 500ohm
tPHZ
Bus Disable Time
tPLZ
BEx to Ax or Bx
1.5
5.5
PI3C3384/PI3C32384 Switching Characteristics over 2.5V Operating Range
Parameters
Description
Conditions(1)
PI3C32X2384
Com.
Units
Min. Max.
tPLH
tPHL
Propogation Delay(2,3) CL = 50pF
Ax to Bx, Bx to Ax RL = 500ohm

1.25
tPZH
tPZL
Bus Enable Time
BEx to Ax or Bx
CL = 50pF
1.5
9.8
ns
RL = 500ohm
tPHZ
Bus Disable Time
tPLZ
BEx to Ax or Bx
1.5
8.3
Notes:
1. See test circuit and waveforms.
2. This parameter is guaranteed but not tested on Propagation Delays.
3. The bus switch contributes no propagational delay other than the RC delay of the ON resistance of the switch and the load
capacitance. The time constant for the switch alone is of the order of 0.25ns for 50pF load. Since this time constant is much
smaller than the rise/fall times of typical driving signals, it adds very little propagational delay to the system. Propagational
delay of the bus switch when used in a system is determined by the driving circuit on the driving side of the switch and its
interaction with the load on the driven side.
3
PS8430A 12/10/99

Share Link: