PI5C3401 View Datasheet(PDF) - Pericom Semiconductor
Part Name
Description
MFG CO.
'PI5C3401' PDF : 5 Pages View PDF
PI5C3401
6-Bit, 3-Port Bus Exchange Switch
Maximum Ratings
(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ..........................................................–65°C to +150°C
Ambient Temperature with Power Applied .........................–40°C to +85°C
Supply Voltage to Ground Potential .....................................–0.5V to +7.0V
DC Input Voltage ..................................................................–0.5V to +7.0V
DC Output Current............................................................................120 mA
Power Dissipation .................................................................................0.5W
Note:
Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at
these or any other conditions above those indicated in the
operational sections of this specification is not implied. Ex-
posure to absolute maximum rating conditions for extended
periods may affect reliability.
DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VCC = 5V ±5%)
Parameters
Description
Test Conditions(1)
Min. Typ(2)
VIH
Input HIGH Voltage
Guaranteed Logic HIGH Level
2.0
VIL
Input LOW Voltage
Guaranteed Logic LOW Level
–0.5
IIH
Input HIGH Current
VCC = Max., VIN = VCC
IIL
Input LOW Current
VCC = Max., VIN = GND
IOZH
High Impedance Output Current 0 ≤ A, B ≤ VCC
VIK
Clamp Diode Voltage
IOS
Short Circuit Current(3)
VCC = Min., IIN = –18 mA
A (B) = 0V, B (A) = VCC
–0.7
100
VH
Input Hysteresis at Control Pins
150
RON
Switch On-Resistance(4)
VCC = Min., VIN = 0.0V, ION = 48mA
VCC = Min., VIN = 2.4V, ION = 15mA
5
10
Max.
0.8
±1
±1
±1
–1.2
7
15
Units
V
µA
V
mA
mV
Ω
Capacitance (TA = 25°C, f = 1 MHz)
Parameters(5)
Description
Test Conditions
Typ.
CIN
Input Capacitance
COFF
A/B Capacitance, Switch Off
VIN = 0V
CON
A/B Capacitance, Switch On
Max.
6
6
8
Units
pF
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at Vcc = 5.0V, TA = 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined by the lower of the
voltages on the two (A,B) pins.
5. This parameter is determined by device characterization but is not production tested.
2
PS7020D
09/16/04
Share Link: 
