RF2705G
Pin Function Description
Interface Schematic
13
RF OUT
Differential low band PA driver amplifier output.
LB N
This output is intended for low band (GSM850/900) operation and drives a
differential SAW.
A bypass mode allows the low band PA driver amplifier’s input to be
switched between the signal from the modulator and the signal applied at
LOLB. This enables a GMSK-modulated signal on the LOLB input to be
switched into the RF signal path.
The output is an open collector. The outputs are matched off-chip.
VCC
VCC VCC
RF OUT LB P
RF OUT LB N
14
RF OUT
Complementary differential low band PA driver amplifier output.
LB P
See pin 13.
See pin 13.
15
RF OUT
Differential high band PA Driver amplifier output.
HB N
This output is intended for DCS1800/PCS1900 band operation.
A bypass mode allows the high band PA driver amplifier’s input to be
switched between the signal from the modulator and the signal applied at
LOHB. This enables a GMSK-modulated DCS1800/PCS1900 signal on the
LOHB input to be switched into the RF signal path.
The output is an open collector. The outputs are matched off-chip.
VCC
VCC VCC
RF OUT HB P
RF OUT HB N
16
RF OUT
Complementary differential high band PA driver amplifier output.
HB P
See pin 15.
17
RF OUT
Differential high band PA driver amplifier output.
WB N
This output is intended for wide band (W-CDMA) applications.
The output is an open collector. The output are matched off-chip.
See pin 15.
VCC
VCC VCC
RF OUT WB P
RF OUT WB N
18
RF OUT
Complementary differential wideband PA driver amplifier output.
WB P
See pin 17.
19
GND
Ground.
20
MODE A Mode control pin. See the Logic Truth table.
CMOS Logic inputs: Logic 0=0V to 0.4V; Logic 1=1.4V to VCC.
21
VCC1
Supply for modulator, VGA and PA driver amplifiers.
See pin 17.
See pin 6.
VCC1
LO Quadrature
Generator and
Buffers
GND1
16 of 26
7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical
support, contact RFMD at (+1) 336-678-5570 or sales-support@rfmd.com.
Rev A0 DS060206