SC4540 View Datasheet(PDF) - Semtech Corporation
Part Name
Description
MFG CO.
'SC4540' PDF : 15 Pages View PDF
SC4540
Applications Information (continued)
Diode Selection
A Schottky diode with a reverse voltage of 60V and a
forward current rating of 1A should be used with this
device for optimum performance. The ST Microelectronics
STPS05602 is a recommended diode for this application.
Selection of Other Components
R sets the maximum load current for the SC4540. Use
ISET
the following equation to select the proper value:
R = 230×V /I
ISET
ISET LOAD
where
VISET = 0.5V (typ).
Refer to Figure 1 for selecting values for other current set-
tings. Note that the error increases as the desired I
BL
current decreases.
PCB Layout Considerations
Poor layout can degrade the performance of the DC-DC
converter and can be a contributory factor in EMI prob-
lems, ground bounce, thermal issues, and resistive voltage
losses. Poor regulation and instability can result. A typical
layout is shown in Figure 4.
The following design rules are recommended:
• Place the inductor and filter capacitors as close
to the device as possible and use short, wide
traces between the power components.
• Route the output voltage feedback path away
from the inductor and LX node to minimize
noise and magnetic interference.
• Use a ground plane to further reduce noise
interference on sensitive circuit nodes.
100
10
R IS E T
Typical
C urrent
T o le ra n c e
1
1
10
100
RISET (kΩ )
Figure 1 – Set Resistor Value Selection Graph
Figure 4– Layout
12
Share Link: 
