ST20-JPI-UK View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'ST20-JPI-UK' PDF : 10 Pages View PDF
ST20-JPI
2.2 Hardware Installation - B300
The ST20-JPI can also be attached to the Ethernet via a B300. To install the hardware connecting
to a B300, the following steps should be followed:
• Connect the B300 to the ST20-JPI using a Differential OS-Link cable supplied with the
B300.
• Plug the target development system into the 20-way IDC connector using a 20 way IDC
cable.
• Plug power supply cable into PSU socket of the interface.
• Plug the power supply into the mains socket.
• Switch on the B300.
• Switch on the power supply to the ST20-JPI. The LEDs on the interface should illuminate
once the software is running. For a description of the meaning of the LEDs, see the ST20
toolset documentation.
• Switch on the Target power supply.
2.3 Software Installation
For installation of the DLL and VxD drivers, please refer to the ST20 Toolset software installation
documentation.
5/10
®
Share Link: 
