Qdatasheet_Logo
Integrated circuits, Transistor, Semiconductors Search and Datasheet PDF Download Site

ST7569 View Datasheet(PDF) - Sitronix Technology Co., Ltd.

Part Name
Description
MFG CO.
ST7569
SITRONIX
Sitronix Technology Co., Ltd. SITRONIX
'ST7569' PDF : 73 Pages View PDF
ST7565S
Column Address Set
This command specifies the column address of the display data RAM shown in Figure 4. The column address is split into two
sections (the higher 4 bits and the lower 4 bits) when it is set (fundamentally, set continuously). Each time the display data RAM
is accessed, the column address automatically increments (+1), making it possible for the MPU to continuously read from/write
to the display data. The column address increment is topped at 83H. This does not change the page address continuously. See
the function explanation in “The Column Address Circuit,” for details.
High bits
Low bits
E R/W
A0 /RD /WR D7 D6 D5 D4 D3 D2 D1 D0 A7 A6 A5 A4 A3 A2 A1 A0
0 1 0 0 0 0 1 A7 A6 A5 A4 0 0 0 0 0 0 0 0
0 A3 A2 A1 A0 0 0 0 0 0 0 0 1
0 00 00 010
1 00 00 010
1 00 00 011
Column
address
0
1
2
130
131
Status Read
E
A0 /RD
0
0
R/W
/WR
1
D7 D6 D5
D4 D3 D2 D1 D0
BUSY ADC ON/OFF RESET 0 0 0 0
BUSY
ADC
ON/OFF
BUSY = 1: it indicates that either processing is occurring internally or a reset condition is in process.
BUSY = 0: A new command can be accepted . if the cycle time can be satisfied, there is no need to check
for BUSY conditions.
This shows the relationship between the column address and the segment driver.
0: Normal (column address n SEG n)
1: Reverse (column address 131-n SEG n)
(The ADC command switches the polarity.)
ON/OFF: indicates the display ON/OFF state.
0: Display ON
1: Display OFF
(This display ON/OFF command switches the polarity.)
RESET
This indicates that the chip is in the process of initialization either because of a /RES signal or because of a
reset command.
0: Operating state
1: Reset in progress
Display Data Write
This command writes 8-bit data to the specified display data RAM address. Since the column address is automatically
incremented by “1” after the write, the MPU can write the display data.
E R/W
A0 /RD /WR
1 10
D7 D6 D5 D4 D3 D2 D1 D0
Write data
Ver 0.3c
43/72
2002/07/22
Share Link: GO URL

All Rights Reserved © qdatasheet.com  [ Privacy Policy ] [ Contact Us ]