ST7MDT2-DVP2 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'ST7MDT2-DVP2' PDF : 82 Pages View PDF
ST7MDT2-DVP2 User Manual
2 - Getting Started
5 EMC-Compliant Probes (optional): In order to work under an EMC-compliant
environment, you will have to clip one EMC-ferrite on both 50-wire flat cables
linking the application to the development kit board. Place this ferrite as close to
the development kit board as possible. You also need to clip one EMC ferrite on
the power supply wire coming from the power supply box. See Figure 4 on
page 13.
Clip ferrite closed
Clip ferrite closed
Figure 4: Connecting the ferrites
6 Connect the passive probe to the appropriate socket on your application board.
For the TQFP64 passive probe, a Yamaichi QFP64 socket has been included.
Follow the instructions in Section 2.4 on page 14 to connect the TQFP64
passive probe to your application board.
7 Plug the DC power supply provided with the development kit into a power outlet.
Connect the power cable to the development board. The green Power LED will
light up.
Note:
The development board can also be fed via the JP1 connector by an external stabilized power
supply (5 V ± 0.25 V, 1 A) not provided with the Kit.
If the board is fed via the JP1 two-point connector make sure that the right feeders lead to the
right polarities.
Caution:
8 Power on the PC and proceed with the installation of the software as described
on Section 3.1 on page 15).
Do not use the jumper connections TP17, TP4 and TP5 — they are for factory testing only and
modifications to them could cause your development board to malfunction. Refer to Section
5.5 on page 50 for a description of all jumpers and solder connections on your development
board.
13/82
Share Link: 
