STCN75 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'STCN75' PDF : 36 Pages View PDF
STCN75
Operation
2.1
Applications information
STCN75 digital temperature sensors are optimal for thermal management and thermal
protection applications. They require no external components for operations except for pull-
up resistors on SCL, SDA, and OS/INT outputs. A 0.1 µF bypass capacitor on VDD is
recommended. The sensing device of STCN75 is the chip itself. The typical interface
connection for this type of digital sensor is shown in Figure 4 on page 11.
Intended applications include:
● System thermal management
● Computers/disk drivers
● Electronics/test equipment
● Power supply modules
● Consumer products
● Battery management
● Fax/printers management
● Automotive
Figure 4. Typical 2-wire interface connections diagram
Pull-up
VDD
10kΩ
VDD
Pull-up
VDD
VDD
STCN75
0.1µF
10kΩ
10kΩ
O.S./INT(1) SCL
A0
SDA(1)
A1
A2
GND
1. SDA and OS/INT are open drain.
Master
Device
I2C Address = 1001000 (1001A2A1A0)
AI12200
2.2
Thermal alarm function
The STCN75 thermal alarm function provides user-programmable thermostat capability and
allows the STCN75 to function as a standalone thermostat without using the serial interface.
The OS/INT output is the alarm output. This signal is an open drain output, and at power-up,
this pin is configured with active-low polarity by default.
Doc ID 13307 Rev 9
11/36
Share Link: 
