STLC5460
TX Monitor Channel selected by Destination Register.
R/W
CM
CR5
CR4
CR3
CR2
CR1
CR0
0
0
-
-
-
LAST
BYTE
INIT
IR/W = 0
CR5/CR3
LAST
BYTE
INIT
Writing auxiliary memory.
not used
Last Byte.
This bit is associated with BYTE.
If LAST = 1, last byte of the message.
If LAST = 0, current byte
Byte to transmit.
When this bit is at 1, the MON channel defined in SRC Register is initialised and the
Monitor Channel is idle (All ”1”s are transmitted)
R/W
CM
CR5
CR4
CR3
CR2
CR1
CR0
1
0
-
T0
ABT
LAST
BYTE
IDLE
R/W = 1
Read auxiliary memory
After writing this register with R/W=1 and when BUSY(status register) has gone to 0, the bits of the
register have the following meaning:
TO
Time Out = one millisecond.
This bit goes to 1 when the remote receiver has not acknowledged the byte after 1
millisecond.
ABT
Abort.
ABT = 1 The remote receiver has aborted the message transmitting.
LAST
Last Byte.
This bit is associated with BYTE.
If LAST = 1, last byte of the message.
If LAST = 0, current byte.
BYTE
BYTE = 1 Byte transmitting.
BYTE = 0 Byte transmitted and acknowledged by the Remote
Receiver, a new byte can be transmitted.
IDLE
IDLE = 1 Monitor channel, A bit, E bit are at ”1”.
RX Monitor channel- Selected by Destination Register
CM
CR5
CR4
CR3
CR2
CR1
CR0
R/W
0
-
-
-
AB
BYTE
EOM
R/W = 1
Read auxiliary memory
After writing this register with R/W=1 and when BUSY(status register) has gone to 0, the bits of the
register have the following meaning:
AB
Abort.
AB = 1 The receiver has detected an error during the transmission.
22/54