SX8801IRXXMLTRT View Datasheet(PDF) - Semtech Corporation
Part Name
Description
MFG CO.
'SX8801IRXXMLTRT' PDF : 135 Pages View PDF
XE8801A – SX8801R
Pos.
7–4
3
2
1
0
RegPBAna
--
PBAna [3]
PBAna [2]
PBAna [1]
PBAna [0]
rw
reset
r
0000
r w 0 resetpconf
r w 0 resetpconf
r w 0 resetpconf
r w 0 resetpconf
description in digital mode
Unused
Set PB[7:6] in analog mode
Set PB[5:4] in analog mode
Set PB[3:2] in analog mode
Set PB[1:0] in analog mode
description in analog mode
Unused
Set PB[7:6] in analog mode
Set PB[5:4] in analog mode
Set PB[3:2] in analog mode
Set PB[1:0] in analog mode
Table 12-6: RegPBAna
Note: Depending on the status of the EnResPConf bit in RegSysCtrl, the reset conditions of the registers are
different. See the reset block documentation for more details on the resetpconf signal.
12.4 Port B capabilities
Port B
name
PB[7]
PB[6]
PB[5]
PB[4]
PB[3]
PB[2]
PB[1]
PB[0]
analog
(high)
analog
analog
analog
analog
usage (priority)
functions
(medium)
uart Rx
uart Tx
usrt S1
usrt S0
32 kHz
clock CPU
PWM1 Counter C (C+D)
PWM0 Counter A (A+B)
digital
(low) (default)
I/O
I/O
I/O
I/O
I/O
I/O
I/O
I/O
Table 12-7: Different Port B functionality
Table 12-7 shows the different usage that can be made of Port B with the order of priority. If a pair of pins is
selected to be analog, it overwrites the function and digital set-up. If the pin is not selected as analog, but a
function is enabled, it overwrites the digital set-up. If neither the analog nor function are selected for a pin, it is used
as an ordinary digital I/O. This is the default configuration at start-up.
12.5 Port B analog capability
12.5.1 Port B analog configuration
Port B terminals can be attached to a 4 line analog bus by setting the PBAna[x] bits to 1 in the RegPBAna
register.
The other registers then define the connection of these 4 analog lines to the different pads of Port B. This can be
used to implement a simple LCD driver or A/D converter. Analog switching is available only when the circuit is
powered with sufficient voltage (see specification below). Below the specified supply voltage, only voltages that are
close to VSS or VBAT can be switched.
When PBAna[x] is set to 1, a pair of Port B terminals is switched from digital I/O mode to analog mode. The usage
of the registers RegPBPullup, RegPBOut and RegPBDir define the analog configuration (see Table 12-8).
When PBAna[x] = 1, then PBPullup[x] connects the pin to the analog bus. PBDir[x] and PBPOut[x] select which
of the 4 analog lines is used. For odd values of x, the selection bits are in the register RegPBOut (see Table 12-8).
For even values of x, the selection bits are in the register RegPBDir (see Table 12-9).
© Semtech 2005
12-3
www.semtech.com
Share Link: 
