USB2502-AEZG View Datasheet(PDF) - SMSC -> Microchip
Part Name
Description
MFG CO.
'USB2502-AEZG' PDF : 44 Pages View PDF
2-Port USB 2.0 Hub Controller
Datasheet
5.3.9.14
Register 0Dh: Max Power For Bus Powered Operation (Reset = 0x00)
BIT
NUMBER
7:0
BIT NAME
MAX_PWR_BP
DESCRIPTION
Max Power Bus_Powered: Value in 2mA increments that the Hub consumes
from an upstream port (VBUS) when operating as a bus-powered hub. This
value includes the hub silicon along with the combined power consumption
(from VBUS) of all associated circuitry on the board. This value also includes
the power consumption of a permanently attached peripheral if the hub is
configured as a compound device, and the embedded peripheral reports
0mA in its descriptors.
A value of 50 (decimal) indicates 100mA.
5.3.9.15 Register 0Eh: Hub Controller Max Current For Self Powered Operation (Reset = 0x00)
BIT
NUMBER
7:0
BIT NAME
HC_MAX_C_SP
DESCRIPTION
Hub Controller Max Current Self-Powered: Value in 2mA increments that the
Hub consumes from an upstream port (VBUS) when operating as a self-
powered hub. This value includes the hub silicon along with the combined
power consumption (from VBUS) of all associated circuitry on the board.
This value does NOT include the power consumption of a permanently
attached peripheral if the hub is configured as a compound device.
Note: The USB 2.0 Specification does not permit this value to exceed
100mA
A value of 50 (decimal) indicates 100mA, which is the default value.
5.3.9.16 Register 0Fh: Hub Controller Max Current For Bus Powered Operation (Reset = 0x00)
BIT
NUMBER
7:0
BIT NAME
HC_MAX_C_BP
DESCRIPTION
Hub Controller Max Current Bus-Powered: Value in 2mA increments that the
Hub consumes from an upstream port (VBUS) when operating as a bus-
powered hub. This value will include the hub silicon along with the combined
power consumption (from VBUS) of all associated circuitry on the board.
This value will NOT include the power consumption of a permanently
attached peripheral if the hub is configured as a compound device.
A value of 50 (decimal) would indicate 100mA, which is the default value.
5.3.9.17 Register 10h: Power-On Time (Reset = 0x00)
BIT
NUMBER
7:0
BIT NAME
DESCRIPTION
POWER_ON_TIME Power On Time: The length of time that it takes (in 2 ms intervals) from the
time the host initiated power-on sequence begins on a port until power is
good on that port.
5.3.9.18
Undefined Registers
The registers shown in Table 5.4 are the defined registers in the Hub. Reads to undefined registers
return 00h. Writes to undefined registers have no effect and do not return an error.
SMSC USB2502
31
DATASHEET
Revision 2.3 (08-27-07)
Share Link: 
