WM8960 View Datasheet(PDF) - Cirrus Logic

Part Name

Description

MFG CO.

WM8960

Stereo CODEC with 1W Stereo Class D Speaker Drivers and Headphone Drivers for Portable Audio Applications

Cirrus Logic 

Prev 31 32 33 34 35 36 37 38 39 40 Next

Production Data

WM8960

REGISTER

ADDRESS

R38 (26h)

Mono Out Mix

(1)

BIT

LABEL

7

L2MO

R39 (27h)

7

Mono Out Mix

(2)

R2MO

R42 (2Ah)

Mono Out

Volume

6

MOUTVOL

Table 23 Output Mixer Enable Control

DEFAULT

DESCRIPTION

0

Left Output Mixer to Mono Output Mixer

Control

0 = Left channel mix disabled

1 = Left channel mix enabled

0

Right Output Mixer to Mono Output

Mixer Control

0 = Right channel mix disabled

1 = Right channel mix enabled

1

Mono Output Mixer Volume Control

0 = 0dB

1 = -6dB

When left and right inputs to the mono mixer are both disabled, the mono mixer will output VMID.

ANALOGUE OUTPUTS

HP_L AND HP_R OUTPUTS

The HP_L and HP_R pins can drive a 16 or 32 headphone or a line output (see Headphone

Output and Line Output sections, respectively). The signal volume on HP_L and HP_R can be

independently adjusted under software control by writing to LOUT1VOL and ROUT1VOL,

respectively. Note that gains over 0dB may cause clipping if the signal is large. Any gain setting below

0101111 (minimum) mutes the output driver. The corresponding output pin remains at the same DC

level (the reference voltage on the VREF pin), so that no click noise is produced when muting or un-

muting.

A zero cross detect on the analogue output may also be enabled when changing the gain setting to

minimize audible clicks and zipper noise as the gain updates. If zero cross is enabled a timeout is

also available to update the gain if a zero cross does not occur. This function may be enabled by

setting TOEN in register R23 (17h). The timeout period is set by TOCLKSEL. Note: SYSCLK must be

enabled to use this function.

w

PD, August 2013, Rev 4.2

37

Share Link: