XRT73L03 View Datasheet(PDF) - Exar Corporation
Part Name
Description
MFG CO.
'XRT73L03' PDF : 62 Pages View PDF
áç
PRELIMINARY
3 CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT XRT73L03
REV. P1.0.13
The MUTing upon LOS feature for each Channel can
be enabled by writing a "1" into the LOSMUT(n) bit-
field in Command Register 3.
COMMAND REGISTER CR3-(N)
D4
D3
D2
D1
D0
SR/(DR)_(n)
LOSMUT(n)
RxOFF(n)
RxClk(n)INV
Reserved
X
1x
x
x
x
NOTE: This step only enables the MUTing upon LOS fea-
ture in Channel(n).
3.6 ROUTING THE RECOVERED TIMING AND DATA
INFORMATION TO THE RECEIVING TERMINAL
EQUIPMENT
3.6.1 Routing Dual-Rail Format Data to the
Receiving Terminal Equipment
Whenever a channel of the XRT73L03 delivers Dual-
Rail format to the Terminal Equipment, it does so via
the following signals:
Each channel in the XRT73L03 takes the Recovered
Timing and Data information, converts it into CMOS
levels and routes it to the Receiving Terminal Equip-
ment via the RPOS(n), RNEG(n) and RxClk(n) output
pins.
Each channel of the XRT73L03 can deliver the recov-
ered data and clock information to the Receiving Ter-
minal in either a Single-Rail or Dual-Rail format.
• RPOS(n)
• RNEG(n)
• RxClk(n)
Figure 24 illustrates the typical interface for the trans-
mission of data in a Dual-Rail Format from the Re-
ceive Section of a channel to the Receiving Terminal
Equipment
.
FIGURE 24. THE TYPICAL INTERFACE FOR THE TRANSMISSION OF DATA IN A DUAL-RAIL FORMAT
FROM THE RECEIVE SECTION OF THE XRT73L03 TO THE RECEIVING TERMINAL EQUIPMENT
RxPOS
Terminal
Equipment
(E3/DS3 or STS-1
Framer)
RxNEG
RxClk
RPOS
RNEG
RxClk
Receive
Logic
Block
Exar E3/DS3/STS-1 LIU
The manner that a given channel transmits Dual-Rail
data to the Receiving Terminal Equipment is de-
scribed below and illustrated in Figure 25. Each
Channel(n) of the XRT73L03 typically updates the
data on the RPOS(n) and RNEG(n) output pins on
the rising edge of RxClk(n).
42
Share Link: 
