XRT75L03 View Datasheet(PDF) - Exar Corporation
Part Name
Description
MFG CO.
'XRT75L03' PDF : 92 Pages View PDF
THREE CHANNEL E3/DS3/STS-1 LINE INTERFACE UNIT WITH JITTER ATTENUATOR
XRT75L03
REV. 1.0.4
TRANSMIT LINE SIDE PINS
PIN #
30
11
21
SIGNAL NAME
TTIP_0
TTIP_1
TTIP_2
TYPE
O
28
TRing_0
O
13
TRing_1
19
TRing_2
DESCRIPTION
Transmit TTIP Output - Positive Polarity Signal - Channel 0:
Transmit TTIP Output - Positive Polarity Signal - Channel 1:
Transmit TTIP Output - Positive Polarity Signal - Channel 2:
These output pins along with the corresponding TRING_n output pins, function
as the Transmit DS3/E3/STS-1 Line output signal drivers for a given channel, of
the XRT75L03.
Connect this signal and the corresponding TRING_n output signal to a 1:1
transformer.
Whenever the Transmit Section of the Channel generates and transmits a posi-
tive-polarity pulse onto the line, this output pin will be pulsed to a "higher-volt-
age" than its corresponding TRING_n output pins.
Conversely, whenever the Transmit Section of the Channel generates and trans-
mit a negative-polarity pulse onto the line, this output pin will be pulsed to a
"lower-voltage" than its corresponding TRING_n output pin.
NOTE: This output pin will be tri-stated whenever the corresponding TxON_n
input pin or bit-field is set to "0".
Transmit Ring Output - Negative Polarity Signal - Channel 0:
Transmit Ring Output - Negative Polarity Signal - Channel 1:
Transmit Ring Output - Negative Polarity Signal - Channel 2:
These output pins along with the corresponding TTIP_n output pins, function as
the Transmit DS3/E3/STS-1 Line output signal drivers for a given channel,
within the XRT75L03.
Connect this signal and the corresponding TTIP_n output signal to a 1:1 trans-
former.
Whenever the Transmit Section of the Channel generates and transmits a posi-
tive-polarity pulse onto the line. This output pin will be pulsed to a "lower-volt-
age" than its corresponding TTIP_n output pins.
Conversely, whenever the Transmit Section of the Channel generates and trans-
mit a negative-polarity pulse onto the line. This output pin will be pulsed to a
"higher-voltage" than its corresponding TTIP_n output pin.
NOTE: This output pin will be tri-stated whenever the corresponding TxON_n
input pin or bit-field is set to "0".
8
Share Link: 
