XRT83SL314IB View Datasheet(PDF) - Exar Corporation
Part Name
Description
MFG CO.
'XRT83SL314IB' PDF : 83 Pages View PDF
xr
14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT
XRT83SL314
REV. 1.0.1
TABLE 17: MOTOROLA MODE: MICROPROCESSOR INTERFACE SIGNALS
XRT83SL314 MOTOROLA
TYPE
PIN NAME EQUIVALENT PIN
DESCRIPTION
ALE_TS
TS
I Transfer Start: This active high signal is used to latch the contents on the
address bus ADDR[7:0]. The contents of the address bus are latched into the
ADDR[7:0] inputs on the falling edge of TS.
WR_R/W
R/W
I Read/Write: This input pin from the local µP is used to inform the LIU
whether a Read or Write operation has been requested. When this pin is
pulled “High”, WE will initiate a read operation. When this pin is pulled
“Low”, WE will initiate a write operation.
RD_WE
WE
I Write Enable: This active low input functions as the read or write signal from the
local µP dependent on the state of R/W. When WE is pulled “Low” (If CS
is “Low”) the LIU begins the read or write operation.
No Pin
OE
I Output Enable: This signal is not necessary for the XRT83SL314 to interface to
the MPC8260 or MPC860 Power PCs.
µPCLK
CLKOUT
I Synchronous Processor Clock: This signal is used as the timing reference for
the Power PC synchronous mode.
RDY_TA
TA
O Transfer Acknowledge: This active low signal is provided by the LIU device. It
indicates that the current read or write cycle is complete, and the LIU is waiting
for the next command.
44
Share Link: 
