C8051T604(2007) Datasheet PDF - Silicon Laboratories

System Overview
C8051T600/1/2/3/4/5 devices are fully integrated mixed-signal System-on-a-Chip MCUs. Highlighted features are listed below. Refer to Table 1.1 on page 14 for specific product feature selection.
With on-chip Power-On Reset, Supply Monitor, Watchdog Timer, and clock oscillator, the C8051T600/1/2/3/4/5 devices are truly stand-alone System-on-a-Chip solutions. User software has complete control of all peripherals, and may individually shut down any or all peripherals for power savings.

Analog Peripherals
- 10-Bit Analog to Digital Converter
    • Up to 500 ksps
    • Up to 8 external inputs
    • VREF from external pin, VDD, or internal regulator
    • Built-in temperature sensor
    • External conversion start input option
- Comparator
    • Programmable hysteresis and response time
    • Configurable as interrupt or reset source
    • Low current (< 0.5 µA)

Memory
- 256 bytes internal data RAM
- 8, 4 or 2 kB one time programmable code memory

On-Chip Debug
- C8051F300 can be used as in-system code development platform; complete development kit available
- On-chip debug circuitry facilitates full speed, non-intrusive in-system debug

Supply Voltage 1.8 to 3.6 V
- On-chip LDO regulator for core supply
- Typical operating current: 5.0 mA @ 25 MHz
- Typical stop mode current (regulator off): <0.1 µA
- Built-in brown-out detector

High Speed 8051 µC Core
- Pipe-lined instruction architecture; executes 70% of instructions in 1 or 2 system clocks
- 25 MIPS peak throughput with 25 MHz clock
- Expanded interrupt handler

Digital Peripherals
- 8 port I/O; All 5 V tolerant with high sink current
- Hardware enhanced UART and SMBus™ serial ports
- Three general purpose 16-bit counter/timers
- 16-Bit programmable counter array (PCA) with three capture/compare modules
    • 8 or 16-bit PWM
    • Rising / falling edge capture
    • Frequency output
    • Software timer

Clock Sources
- Internal oscillator: 24.5 MHz with ±2% accuracy supports UART operation
- External oscillator: RC, Single Capacitor, or CMOS Clock Modes
- Can switch between clock sources on-the-fly; useful in power saving modes

Temperature Range: –40 to +85 °C
11-Pin QFN or 14-Pin SOIC Package
- QFN Size = 3 x 3 mm