GPR25L25606F Datasheet PDF - Generalplus Technology Inc.

GENERAL DESCRIPTION
The GPR25L25606F (256M-bit) Serial flash supports the standard Serial Peripheral Interface (SPI), and supports the Dual/Quad SPI: Serial Clock, Chip Select, Serial Data I/O0 (SI), I/O1 (SO), I/O2 (WP#), and I/O3 (HOLD#/ RESET#). The Dual I/O data is transferred with speed of 160Mbits/s and the Quad I/O & Quad output data is transferred with speed of 320Mbits/s.

FEATURES
✦ 256M-bit Serial Flash
   -32M-byte
   -256 bytes per programmable page
✦ Standard, Dual, Quad SPI
   -Standard SPI: SCLK, CS#, SI, SO, WP#, HOLD#/ RESET#
   -Dual SPI: SCLK, CS#, IO0, IO1, WP#, HOLD#/ RESET#
   -Quad SPI: SCLK, CS#, IO0, IO1, IO2, IO3
   -3 or 4-Byte Addressing Mode
✦ High Speed Clock Frequency
   -Maximum 80MHz for fast read on 3.0 - 3.6V power supply
      ✦ Dual I/O Data transfer up to 160Mbits/s
      ✦ Quad I/O Data transfer up to 320Mbits/s
   -Maximum 60MHz for fast read on 2.7 - 3.6V power supply
      ✦ Dual I/O Data transfer up to 120Mbits/s
      ✦ Quad I/O Data transfer up to 240Mbits/s
✦ Software/Hardware Write Protection
   -Write protect all/portion of memory via software
   -Enable/Disable protection with WP# Pin
   -Top or Bottom, Complement Block selection
   -768-Byte (3*256-Byte) Security Registers With OTP Locks
✦ Allows XIP(execute in place)operation(1)
✦ Program/Erase Speed
   -Page Program time: 0.6ms typical
   -Sector Erase time: 50ms typical
   -Block Erase time: 0.2/0.3s typical
   -Chip Erase time: 100s typical
✦ Flexible Architecture
   -Sector of 4K-byte
   -Block of 32/64k-byte
✦ Low Power Consumption
   -30uA typical standby current
   -1uA typical power down current
✦ Advanced Security Features
   -3*256-Byte Security Registers With OTP Locks
   -128-bit Unique ID for each device
   -Serial Flash Discoverable parameters(SFDP) register
✦ Single Power Supply Voltage
   -Full voltage range:2.7~3.6V
✦ Package Information
   -SOP16 (300mil)