AN2125 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'AN2125' PDF : 68 Pages View PDF
uPSD3300 Series Design Guide for DK3300-ELCD Using KEIL
Figure 46. Target Connect test
Figure 47. JTAG-ISP Message
7.10 Watch It Run On DK3300-ELCD
After JTAG programming completes in just a few seconds, you should see a message appear
on the LCD: "PWM to ADC DEMO"
You will see the HEX value of the ADC conversion sweep up and down between 0x000 and
0x3FF as the PWM pulse width changes. If you do not see the ADC value change, make sure
there are two jumpers installed on the DK3300-ELCD board. They are JP14. Remove the
jumper and watch the ADC value on the LCD drop to 000 hex.
56/68
1
Share Link: 
