ASMT-YTC2-0AA02 View Datasheet(PDF) - Avago Technologies
Part Name
Description
MFG CO.
'ASMT-YTC2-0AA02' PDF : 12 Pages View PDF
Soldering
Recommended reflow soldering condition:
(i) Leaded reflow soldering:
(ii) Lead-free reflow soldering:
20 SEC. MAX.
240°C MAX.
3°C/SEC. MAX.
100-150°C
183°C
3°C/SEC.
MAX.
-6°C/SEC.
MAX.
120 SEC. MAX. 60-150 SEC.
TIME
a. Reflow soldering must not be done more than 2 times.
Make sure the necessary precautions are observed for
handling moisture-sensitive device as stated in the
following section.
b. Recommended board reflow direction:
217°C
200°C
150°C
255 - 260 °C
3°C/SEC. MAX.
3 °C/SEC. MAX.
60 - 120 SEC.
10 to 30 SEC.
6°C/SEC. MAX.
100 SEC. MAX.
TIME
c. Do not apply any pressure or force on the LED during
reflow and after reflow when the LED is still hot.
d. It is preferred to use reflow soldering to solder the LED.
Use hand soldering for rework if this is unavoidable,
but it must be strictly controlled to the following
conditions:
- Soldering iron tip temperature = 320 °C max
- Soldering duration = 3 sec max
- Number of cycles = 1 only
- Power of soldering iron = 50 W max
e. Do not touch the LED body with hot soldering iron
except the soldering terminals as it may cause damage
to the LED.
f. For de-soldering, it is recommended that you use a
double flat tip.
g. You are advised to confirm beforehand whether hand
soldering will affect the functionality and performance
of the LED.
REFLOW DIRECTION
10
Share Link: 
