C8051F362 View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
MFG CO.
'C8051F362' PDF : 288 Pages View PDF
C8051F360/1/2/3/4/5/6/7/8/9
9. CIP-51 Microcontroller
The MCU system controller core is the CIP-51 microcontroller. The CIP-51 is fully compatible with the
MCS-51™ instruction set; standard 803x/805x assemblers and compilers can be used to develop soft-
ware. The MCU family has a superset of all the peripherals included with a standard 8051. Included are
five 16-bit counter/timers (see description in Section 21), one full-duplex UART (see description in Section
19), 256 bytes of internal RAM, 128 byte Special Function Register (SFR) address space (see Section
9.4.6), and up to four byte-wide and one 7-bit-wide I/O Ports (see description in Section 17). The CIP-51
also includes on-chip debug hardware (see description in Section 24), and interfaces directly with the
MCU’s analog and digital subsystems providing a complete data acquisition or control-system solution in a
single integrated circuit.
The CIP-51 Microcontroller core implements the standard 8051 organization and peripherals as well as
additional custom peripherals and functions to extend its capability (see Figure 9.1 for a block diagram).
- Fully Compatible with MCS-51 Instruction
Set
- 100 or 50 MIPS Peak Using the On-Chip
PLL
- 256 Bytes of Internal RAM
- 8/4 Byte-Wide I/O Ports
- Extended Interrupt Handler
- Reset Input
- Power Management Modes
- On-chip Debug Logic
The CIP-51 includes the following features:
9.1. Performance
The CIP-51 employs a pipelined architecture that greatly increases its instruction throughput over the stan-
dard 8051 architecture. In a standard 8051, all instructions except for MUL and DIV take 12 or 24 system
clock cycles to execute, and usually have a maximum system clock of 12 MHz. By contrast, the CIP-51
core executes 70% of its instructions in one or two system clock cycles, with no instructions taking more
than eight system clock cycles.
With the CIP-51's system clock running at 100 MHz, it has a peak throughput of 100 MIPS. The CIP-51
has a total of 109 instructions. The table below shows the total number of instructions that require each
execution time.
Clocks to Execute
1
2
2/3
3
3/4
4
4/5
5
8
Number of Instructions 26
50
5
14
7
3
1
2
1
80
Rev. 1.0
Share Link: 
