CC1111F16RSPR View Datasheet(PDF) - TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS
Part Name
Description
MFG CO.
CC1111F16RSPR
TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS
'CC1111F16RSPR' PDF : 240 Pages View PDF
CC1110Fx / CC1111Fx
SLEEP (0xBE) – Sleep Mode Control
Bit Name
Reset
R/W
Description
7
USB_EN
0
R/W USB Enable (CC1111Fx). This bit is unused for CC1110Fx
0 Disable (Setting this bit to 0 will reset the USB controller)
1 Enable
This bit will be 0 when returning from PM2 and PM3
6
XOSC_STB 0
R
High speed crystal oscillator (fXOSC) stable status
0 Oscillator is not powered up or not yet stable
1 Oscillator is powered up and stable
5
HFRC_STB 0
R
High speed RC oscillator (HS RCOSC) stable status
0 Oscillator is not powered up or not yet stable
1 Oscillator is powered up and stable
4:3 RST[1:0]
XX
R
Status bit indicating the cause of the last reset. If there are multiple resets, the
register will only contain the last event.
00 Power-on reset or Brown-out reset
01 External reset
10 Watchdog timer reset
2
OSC_PD
1
R/W High speed XOSC and HS RCOSC power down setting. The bit is cleared if
H0
the CLKCON.OSC bit is toggled. If there is a calibration in progress and the
CPU attempts to set this bit, the bit will be updated at the end of calibration.
0 Both oscillators powered up
1 Oscillator not selected by CLKCON.OSC bit powered down
1:0 MODE[1:0] 00
R/W Power mode setting
00 PM0
01 PM1
10 PM2
11 PM3
These bits will be 0 when entering PM1, PM2 and PM3.
Note: It is necessary to clear the MODE bits before returning from all ISRs
associated with interrupts that can be used to wake the device from PM{1-3}.
See section 13.1.3 for details
13.1.5 Oscillators and Clocks
The CC1110Fx/CC1111Fx has one internal system
clock. The source for the system clock can be
either a high speed RC oscillator or a high
speed crystal oscillator. The crystal oscillator
for CC1110Fx operates at 24 - 27 MHz while the
crystal oscillator for CC1111Fx operates at 48
MHz. The 24 - 27 MHz clock is used directly
as the system clock for CC1110Fx. On CC1111Fx,
the 48 MHz clock is used by the USB
Controller only while a derived 24 MHz clock is
used as the system clock. The source for the
system clock is selected by the CLKCON.OSC
bit.
There is also one 32 kHz clock source that can
either be a low power RCOSC or a 32.768 kHz
crystal oscillator. This is controlled by the
CLKCON.OSC32K bit.
The choice of oscillator allows a trade-off
between high-accuracy in the case of the
crystal oscillator and low power consumption
when the RC oscillator is used. Note that
operation of the RF transceiver requires that
the high speed crystal oscillator is used.
Note: The high speed crystal oscillator
must be stable (SLEEP.XOSC_STB=1)
before using the radio.
13.1.5.1 High Speed Oscillators
Two high speed oscillators are present in the
device:
• High speed crystal oscillator (24 – 27
MHz for CC1110Fx and 48 MHz for
CC1111Fx)
SWRS033E
Page 80 of 239
Share Link: 