L5987 View Datasheet(PDF) - STMicroelectronics
Part Name
Description
MFG CO.
'L5987' PDF : 40 Pages View PDF
L5987
6.3
Application information
Output capacitor selection
The current in the capacitor has a triangular waveform which generates a voltage ripple
across it. This ripple is due to the capacitive component (charge or discharge of the output
capacitor) and the resistive component (due to the voltage drop across its ESR). So the
output capacitor has to be selected in order to have a voltage ripple compliant with the
application requirements.
The amount of the voltage ripple can be calculated starting from the current ripple obtained
by the inductor selection.
Equation 13
VOUT = ESR IMAX + -8-------C-----O--I--MU----TA---X----f--S---W---
Usually the resistive component of the ripple is much higher than the capacitive one, if the
output capacitor adopted is not a multi-layer ceramic capacitor (MLCC) with very low ESR
value.
The output capacitor is important also for loop stability: it fixes the double LC filter pole and
the zero due to its ESR. In Section 6.4 it will be illustrated how to consider its effect in the
system stability.
For example: with VOUT = 3.3 V, VIN = 12 V, IL = 0.9 A (resulting by the inductor value), in
order to have a VOUT = 0.01·VOUT, if the multi-layer ceramic capacitors are adopted, 13 F
are needed and the ESR effect on the output voltage ripple can be neglected. In case of not
negligible ESR (electrolytic or tantalum capacitors), the capacitor is chosen taking into
account its ESR value. So in case of 330 F with ESR = 30 m, the resistive component of
the drop dominates and the voltage ripple is 27 mV
The output capacitor is also important to sustain the output voltage when a load transient
with high slew rate is required by the load. When the load transient slew rate exceeds the
system bandwidth the output capacitor provides the current to the load. So if the high slew
rate load transient is required by the application the output capacitor and system bandwidth
have to be chosen in order to sustain the load transient.
In Table 8 some capacitor series are listed.
Manufacturer
MURATA
Panasonic
SANYO
TDK
Table 8. Output capacitors
Series
Cap value (F) Rated voltage (V)
GRM32
22 to 100
6.3 to 25
GRM31
10 to 47
6.3 to 25
ECJ
10 to 22
6.3
EEFCD
10 to 68
6.3
TPA/B/C
100 to 470
4 to 16
C3225
22 to 100
6.3
ESR (m)
<5
<5
<5
15 to 55
40 to 80
<5
DocID14972 Rev 4
19/40
40
Share Link: 
