LPC1777 View Datasheet(PDF) - NXP Semiconductors.
Part Name
Description
MFG CO.
LPC1777
NXP Semiconductors.
'LPC1777' PDF : 120 Pages View PDF
NXP Semiconductors
LPC178x/7x
32-bit ARM Cortex-M3 microcontroller
during a given data transfer. The SSP supports full duplex transfers, with frames of 4 bits
to 16 bits of data flowing from the master to the slave and from the slave to the master. In
practice, often only one of these data flows carries meaningful data.
7.21.1 Features
• Maximum SSP speed of 33 Mbit/s (master) or 10 Mbit/s (slave).
• Compatible with Motorola SPI, 4-wire Texas Instruments SSI, and National
Semiconductor Microwire buses.
• Synchronous serial communication.
• Master or slave operation.
• 8-frame FIFOs for both transmit and receive.
• 4-bit to 16-bit frame.
• DMA transfers supported by GPDMA.
7.22 I2C-bus serial I/O controllers
The LPC178x/7x contain three I2C-bus controllers.
The I2C-bus is bidirectional for inter-IC control using only two wires: a Serial Clock Line
(SCL) and a Serial Data Line (SDA). Each device is recognized by a unique address and
can operate as either a receiver-only device (e.g., an LCD driver) or a transmitter with the
capability to both receive and send information (such as memory). Transmitters and/or
receivers can operate in either master or slave mode, depending on whether the chip has
to initiate a data transfer or is only addressed. The I2C is a multi-master bus and can be
controlled by more than one bus master connected to it.
7.22.1 Features
• All I2C-bus controllers can use standard GPIO pins with bit rates of up to 400 kbit/s
(Fast I2C-bus). The I2C0-bus interface uses special open-drain pins with bit rates of
up to 400 kbit/s.
• The I2C-bus interface supports Fast-mode Plus with bit rates up to 1 Mbit/s for I2C0
using pins P5[2] and P5[3].
• Easy to configure as master, slave, or master/slave.
• Programmable clocks allow versatile rate control.
• Bidirectional data transfer between masters and slaves.
• Multi-master bus (no central master).
• Arbitration between simultaneously transmitting masters without corruption of serial
data on the bus.
• Serial clock synchronization allows devices with different bit rates to communicate via
one serial bus.
• Serial clock synchronization can be used as a handshake mechanism to suspend and
resume serial transfer.
• The I2C-bus can be used for test and diagnostic purposes.
• Both I2C-bus controllers support multiple address recognition and a bus monitor
mode.
LPC178X_7X
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 5.5 — 26 April 2016
© NXP Semiconductors N.V. 2016. All rights reserved.
54 of 126
Share Link: 