LPC47B272-MS View Datasheet(PDF) - SMSC -> Microchip
Part Name
Description
MFG CO.
'LPC47B272-MS' PDF : 195 Pages View PDF
Table 23 - Verify Command Result Phase
MT
EC
SC/EOT VALUE
TERMINATION RESULT
0
0
SC = DTL
Success Termination
EOT ≤ # Sectors Per Side
Result Phase Valid
0
0
SC = DTL
Unsuccessful Termination
EOT > # Sectors Per Side
Result Phase Invalid
0
1
SC ≤ # Sectors Remaining AND
Successful Termination
EOT ≤ # Sectors Per Side
Result Phase Valid
0
1
SC > # Sectors Remaining OR
Unsuccessful Termination
EOT > # Sectors Per Side
Result Phase Invalid
1
0
SC = DTL
Successful Termination
EOT ≤ # Sectors Per Side
Result Phase Valid
1
0
SC = DTL
Unsuccessful Termination
EOT > # Sectors Per Side
Result Phase Invalid
1
1
SC ≤ # Sectors Remaining AND
Successful Termination
EOT ≤ # Sectors Per Side
Result Phase Valid
1
1
SC > # Sectors Remaining OR
Unsuccessful Termination
EOT > # Sectors Per Side
Result Phase Invalid
Note: If MT is set to "1" and the SC value is greater than the number of remaining formatted sectors on Side 0,
verifying will continue on Side 1 of the disk.
Format A Track
The Format command allows an entire track to be formatted. After a pulse from the nINDEX pin is detected, the FDC
starts writing data on the disk including gaps, address marks, ID fields, and data fields per the IBM System 34 or 3740
format (MFM or FM respectively). The particular values that will be written to the gap and data field are controlled by the
values programmed into N, SC, GPL, and D which are specified by the host during the command phase. The data field
of the sector is filled with the data byte specified by D. The ID field for each sector is supplied by the host; that is, four
data bytes per sector are needed by the FDC for C, H, R, and N (cylinder, head, sector number and sector size
respectively).
After formatting each sector, the host must send new values for C, H, R and N to the FDC for the next sector on the
track. The R value (sector number) is the only value that must be changed by the host after each sector is formatted.
This allows the disk to be formatted with nonsequential sector addresses (interleaving). This incrementing and
formatting continues for the whole track until the FDC encounters a pulse on the nINDEX pin again and it terminates the
command.
Table 24 contains typical values for gap fields which are dependent upon the size of the sector and the number of
sectors on each track. Actual values can vary due to drive electronics.
SMSC LPC47B27x
- 47 -
DATASHEET
Rev. 04-17-07
Share Link: 
