MAS9116ASBA View Datasheet(PDF) - Micro Analog systems
Part Name
Description
MFG CO.
'MAS9116ASBA' PDF : 18 Pages View PDF
DA9116.005
22 November, 2005
Serial Interface Timing
TWHC TWLC
TRC TFC
CCLK
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
THCSH
XCS
TSSLCH
THLCHS
TSSHCH
DATA
(IN)
TSDCH
THCHD
76 543 2 10 76 543 210
TDCLD
TDSZ
DATA
(OUT)
ADDRESS BYTE
7 6 543 210
DATA BYTE
APPLICATION INFORMATION
Power supply connection and decoupling
To get the best performance of the chip all digital
activities should be avoided during analog signal
processing.
Important: Analog (AVDD) and digital (DVDD)
supply voltage pins should be always connected
directly together to keep them in the same voltage
potential. No resistor is allowed in connection
between AVDD and DVDD (see supply voltage
connection circuit in the Application Note 1 on the
next page). Otherwise possible voltage difference
could trigger latch-up phenomenom which can
damage the device. Due to the same reason also
the digital control input voltages should not exceed
supply and ground voltages as specified in absolute
maximum rating specifications on page 6. These
requirements are valid also during the startup when
supply voltages are applied.
Low noise supply voltages should be used for high
quality audio. Supply decoupling capacitors must be
located as close to MAS9116 as possible.
Opamp produced output offset voltage
Opamp non-idealities in input offset voltage and in
input bias current both produce offset voltage to the
output. Since this offset voltage is gain dependent
the gain change step can produce dc voltage steps
to the output. To achieve the best audio
performance it is recommended to use opamps
which have both low input offset voltage and low
input bias current characteristics. Burr-Brown
OP277 has excellent offset and bias and no
trimming is needed. Also Analog Devices OP1177
and AD8610 offer very good offset performance.
See table below for these and other recommended
op-amps.
Manufacturer
Analog Devices
Analog Devices
Analog Devices
Texas Instruments (BurrBrown)
Linear
On-Semi, ST Microelectronics
Part Number
OP275
OP1177
AD8610
OP277
LT1793
MC33078
Typical Output Offset at
Maximum Gain (mV)
8.5
0.51
1.49
0.23
18.5
28.4
11 (18)
Share Link: 
