MPC5607B View Datasheet(PDF) - Freescale Semiconductor
Part Name
Description
MFG CO.
'MPC5607B' PDF : 110 Pages View PDF
Package pinouts and signal descriptions
1 Alternate functions are chosen by setting the values of the PCR.PA bitfields inside the SIUL module.
PCR.PA = 00 AF0; PCR.PA = 01 AF1; PCR.PA = 10 AF2; PCR.PA = 11 AF2. This is intended to select
the output functions; to use one of the input functions, the PCR.IBE bit must be written to ‘1’, regardless of the values
selected in the PCR.PA bitfields. For this reason, the value corresponding to an input only function is reported as “—”.
2 Multiple inputs are routed to all respective modules internally. The input of some modules must be configured by
setting the values of the PSMIO.PADSELx bitfields inside the SIUL module.
3 The RESET configuration applies during and after reset.
4 208 MAPBGA available only as development package for Nexus2+
5 All WKPU pins also support external interrupt capability. See the WKPU chapter for further details.
6 NMI has higher priority than alternate function. When NMI is selected, the PCR.AF field is ignored.
7 “Not applicable” because these functions are available only while the device is booting. Refer to the BAM information
for details.
8 Value of PCR.IBE bit must be 0
9 This wakeup input cannot be used to exit STANDBY mode.
10 Out of reset all the functional pins except PC[0:1] and PH[9:10] are available to the user as GPIO.
PC[0:1] are available as JTAG pins (TDI and TDO respectively).
PH[9:10] are available as JTAG pins (TCK and TMS respectively).
It is up to the user to configure these pins as GPIO when needed.
11 PC[1] is a fast/medium pad but is in medium configuration by default. This pad is in Alternate Function 2 mode after
reset which has TDO functionality. The reset value of PCR.OBE is ‘1’, but this setting has no impact as long as this
pad stays in AF2 mode. After configuring this pad as GPIO (PCR.PA = 0), output buffer is enabled as reset value of
PCR.OBE = 1.
12 Not available in 100 LQFP package
3.8 Nexus 2+ pins
In the 208 MAPBGA package, eight additional debug pins are available (see Table 6).
Table 6. Nexus 2+ pin descriptions
Port pin
Function
I/O
direction
Pad type
Function
after reset
MCKO
Message clock out
O
F
—
MDO0
Message data out 0
O
M
—
MDO1
Message data out 1
O
M
—
MDO2
Message data out 2
O
M
—
MDO3
Message data out 3
O
M
—
EVTI
Event in
I
M
Pull-up
EVTO
Event out
O
M
—
MSEO Message start/end out
O
M
—
1 208 MAPBGA available only as development package for Nexus2+
Pin number
100
LQFP
—
—
—
—
—
—
—
—
144
LQFP
—
—
—
—
—
—
—
—
208 MAP
BGA1
T4
H15
H16
H14
H13
K1
L4
G16
MPC5607B Microcontroller Data Sheet, Rev. 6
Freescale Semiconductor
33
Share Link: 
