MPC8349VVAGFB View Datasheet(PDF) - Freescale Semiconductor

Part Name

Description

MFG CO.

MPC8349VVAGFB

PowerQUICC II Pro Integrated Host Processor Hardware Specifications

Freescale Semiconductor 

Prev 81 82 83 84 85 86 87

System Design Information

have a low ESR (equivalent series resistance) rating to ensure the quick response time. They should also

be connected to the power and ground planes through two vias to minimize inductance. Suggested bulk

capacitors are 100–330 µF (AVX TPS tantalum or Sanyo OSCON).

21.4 Connection Recommendations

To ensure reliable operation, connect unused inputs to an appropriate signal level. Unused active low

inputs should be tied to OVDD, GVDD, or LVDD as required. Unused active high inputs should be

connected to GND. All NC (no-connect) signals must remain unconnected.

Power and ground connections must be made to all external VDD, GVDD, LVDD, OVDD, and GND pins of

the MPC8349EA.

21.5 Output Buffer DC Impedance

The MPC8349EA drivers are characterized over process, voltage, and temperature. For all buses, the

driver is a push-pull single-ended driver type (open drain for I2C).

To measure Z0 for the single-ended drivers, an external resistor is connected from the chip pad to OVDD

or GND. Then the value of each resistor is varied until the pad voltage is OVDD/2 (see Figure 43). The

output impedance is the average of two components, the resistances of the pull-up and pull-down devices.

When data is held high, SW1 is closed (SW2 is open) and RP is trimmed until the voltage at the pad equals

OVDD/2. RP then becomes the resistance of the pull-up devices. RP and RN are designed to be close to each

other in value. Then, Z0 = (RP + RN) ÷ 2.

OVDD

Data

RN

SW2

Pad

SW1

RP

OGND

Figure 43. Driver Impedance Measurement

Two measurements give the value of this resistance and the strength of the driver current source. First, the

output voltage is measured while driving logic 1 without an external differential termination resistor. The

measured voltage is V1 = Rsource × Isource. Second, the output voltage is measured while driving logic 1

with an external precision differential termination resistor of value Rterm. The measured voltage is

MPC8349EA PowerQUICC II Pro Integrated Host Processor Hardware Specifications, Rev. 13

Freescale Semiconductor

81

Share Link: