RC224ATL View Datasheet(PDF) - Conexant Systems
Part Name
Description
MFG CO.
'RC224ATL' PDF : 104 Pages View PDF
RC224ATL/224ATLV
EmbeddedModem Family
5.0 S Registers
Table 5-2. S Register Description (5 of 8)
Register
S22
Default
76h
Range
Bit Mapped
Units
—
Description
Bit Mapped Options. S22 is the modem register with the following
bit functions:
Bit 0, 1 Speaker Volume (See L Command)
10
0 0 L0—Speaker volume low
0 1 L1—Speaker volume low
1 0 L2—Speaker volume medium (factory default)
1 1 L3—Speaker volume high
Bit 2, 3 Speaker Control (See M Command)
32
0 0 M0—Speaker disabled
0 1 M1—Speaker on until carrier detected (factory
default)
1 0 M2—Speaker always on
1 1 M3—Speaker on until carrier detected but off
during dialing
Bit 4, 5, 6Result Code Options (See X Command)
654
000
X0—Selects appropriate connect result code,
goes off-hook when the dial command is
received, waits the number of nds given by
register S6, and “blind dials” (does not look
for dial tone).
0 0 1 Reserved
0 1 0 Reserved
0 1 1 Reserved
100
X1—Selects appropriate connect result code,
goes off-hook, waits the number of seconds
specified by register S6 and blind dials
without waiting for dial tone. Busy is not
detected.
101
X2—Selects appropriate connect result code,
goes off-hook, and dials when dial tone is
detected. Busy is not detected.
110
X3—Selects appropriate connect result code,
goes off-hook, waits the number of seconds
specified in register S6, blind dials, detects
busy signal and sends BUSY result code.
111
X4—Selects appropriate connect result code,
goes off-hook and dials when dial tone is
detected, detects busy signal and sends BUSY
result code. All result codes are enabled
(factory default).
Bit 7 Make/Break Ratio (See &P Command)
0
&P0—39/61 United States/Canada (factory
default)
1
&P1—33/67 UK/Hong Kong
D224ATLVDSC
Conexant
5-7
Share Link: 
